Bedienungsanleitung BEKO WMY 71443 LMB2 (Seite 28 von 44) (Deutsch, Englisch)

579430

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

28 / EN

Washing Machine / User’s Manual

3.AttachtheplasticcoverssuppliedintheUserManualbag

into the holes on the rear panel.

(P)

Keepthetransportationsafetyboltsinasafeplaceto

reusewhenthewashingmachineneedstobemoved

again in the future.

Nevermovetheproductwithoutthetransportationsafety

boltsproperlyfixedinplace!

2.4 Connecting water supply

Thewatersupplypressurerequiredtoruntheproductis

between1to10bars(0.1–1MPa).Itisnecessaryto

have10–80litersofwaterflowingfromthefullyopen

tapinoneminutetohaveyourmachinerunsmoothly.

Attachapressurereducingvalveifwaterpressureis

higher.

If you are going to use the double water-inlet product

as a single

(cold) water-inlet unit, you must install the

suppliedstoppertothehotwatervalvebeforeoperating

theproduct.(Appliesfortheproductssuppliedwitha

blind stopper group.)

WARNING: Models with a single water inlet should not

be connected to the hot water tap. In such a case the

laundry will get damaged or the product will switch to

protection mode and will not operate.

WARNING: Do not use old or used water inlet hoses

on the new product. It may cause stains on your laundry.

1.Connectthespecialhosessuppliedwiththeproductto

thewaterinletsontheproduct.Redhose(left)(max.90

ºC)isforhotwaterinlet,bluehose(right)(max.25ºC)is

for cold water inlet.

WARNING: Ensure that the cold and hot water

connections are made correctly when installing the

product. Otherwise, your laundry will come out hot at the

end of the washing process and wear out.

2.Tightenallhosenutsbyhand.Neveruseatoolwhen

tightening the nuts.

3. Open the taps completely after making the hose

connection to check for water leaks at the connection

points.Ifanyleaksoccur,turnoffthetapandremovethe

nut.Retightenthenutcarefullyaftercheckingtheseal.To

preventwaterleakagesanddamagescausedbythem,

keep the taps closed when the machine is not in use.

2.5 Connecting to the drain

• Theendofthedrainhosemustbedirectlyconnectedto

the wastewater drain or to the washbasin.

WARNING: Your house will be flooded if the hose

comes out of its housing during water discharge.

Moreover,thereisriskofscaldingduetohighwashing

temperatures!Topreventsuchsituationsandtoensure

smoothwaterintakeanddischargeofthemachine,fix

the end of the discharge hose tightly so that it cannot

come out.

• Thehoseshouldbeattachedtoaheightofatleast40

cm, and 100 cm at most.

• Incasethehoseiselevatedafterlayingitonthefloor

levelorclosetotheground(lessthan40cmabovethe

ground), water discharge becomes more difficult and the

laundrymaycomeoutexcessivelywet.Therefore,follow

the heights described in the figure.

100cm

40cm

• Topreventflowingofdirtywaterbackintothemachine

and to allow for easy discharge, do not immerse the hose

endintothedirtywaterordonotdriveitinthedrainmore

than 15 cm. If it is too long, cut it short.

• Theendofthehoseshouldnotbebent,itshouldnotbe

stepped on and the hose must not be pinched between

the drain and the machine.

• Ifthelengthofthehoseistooshort,useitbyadding

anoriginalextensionhose.Lengthofthehosemay

notbelongerthan3.2m.Toavoidwaterleakfailures,

theconnectionbetweentheextensionhoseandthe

drain hose of the product must be fitted well with an

appropriate clamp as not to come off and leak.

2.6 Adjusting the feet

WARNING: In order to ensure that the product

operatesmoresilentlyandvibration-free,itmuststand

levelandbalancedonitsfeet.Balancethemachine

by adjusting the feet. Otherwise, the product may

movefromitsplaceandcausecrushingandvibration

problems.

1. Loosen the lock nuts on the feet by hand.

2.Adjustthefeetuntiltheproductstandsleveland

balanced.

3.Tightenalllocknutsagainbyhand.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WMY 71443 LMB2 Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info