Bedienungsanleitung BEKO WTV8711BC1 (Seite 22 von 56) (Deutsch, Englisch)

757608

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

22 / EN Washing Machine / User Manual

INFORMATION

• Foreign metal substances will cause rust

stains in the drum. Clean the stains on the

drum surface by using cleaning agents for

stainless steel.

WARNING

• Never use steel wool or wire wool. These

will damage the painted, chromated and

plastic surfaces.

4.4.3 Cleaning the body

and control panel

Wipe the body of the machine with soapy

water or non-corrosive mild gel detergents as

necessary, and dry with a soft cloth.

Use only a soft and damp cloth to clean the

control panel.

4.4.4 Cleaning the water intake filters

There is a filter at the end of each water intake

valve at the rear of the machine and also at

the end of each water intake hose where they

are connected to the tap. These filters prevent

foreign substances and dirt in the water to

enter the washing machine. Filters should be

cleaned as they do get dirty.

1. Close the taps.

2. Remove the nuts of the water intake hoses

to access the filters on the water intake

valves. Clean them with an appropriate

brush. If the filters are too dirty, remove

them from their places with a pliers and

clean in this way.

Take out the filters on the flat ends of the

water intake hoses together with the gaskets

and clean thoroughly under running water.

4. Replace the seals and filters carefully and

tighten their nuts by hand ensuring there are

no leaks.

4.4.5 Draining remaining water

and cleaning the pump filter

The filter system in your machine prevents

solid items such as buttons, coins and fabric

fibres clogging the pump impeller during

discharge of washing water. Thus, the water

will be discharged without any problem and the

service life of the pump will extend.

If the machine fails to drain water, the pump filter

is clogged. Filter must be cleaned whenever it

is clogged or in every 3 months. Water must be

drained off first to clean the pump filter.

In addition, prior to transporting the machine

(e.g., when moving to another house) and in

case of freezing of the water, water may have

to be drained completely.

CAUTION!

• Foreign substances left in the pump filter

may damage your machine or may cause

noise problem.

• If the product is not being used, shut the

tap shut, remove mains pipe and drain the

water inside the machine against any likely

freezing.

• After each use, turn off the water tap to

which the mains hose is connected.

In order to clean the dirty filter and discharge

the water:

1 Unplug the machine to cut off the supply

power.

CAUTION!

• Temperature of the water inside the

machine may rise up to 90 ºC. To avoid the

burning risk, clean the filter after the water

inside the machine is cooled down.

2. Open the filter cover.

3 Follow the below procedures in order to

drain water.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WTV8711BC1 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von BEKO WTV8711BC1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info