Belinea 10 19 15 - Operating Instructions - 4
ENGLISH
➧ To connect the monitor to your PC ........................
1. Make sure that the PC and monitor are unplugged.
2. Connect the 15-pin signal cable to the PC (see
fi g . 2 a ) .
If you have a graphic card with a digital DVI-D con-
nector (24-pin socket), then connect one end of the
DVI-D cable (optional) to the DVI-D connector of
your monitor (see fi g. 2b), the other end to the com-
puter.
➧ To connect the monitor to the power source ........
Connect the separate power cable (
in fi g. 3) to the
monitor and a grounded outlet.
➧ Connecting the audio cable ...................................
If your computer is equipped with an audio output port,
then connect one end of the sound cable to the audio
input connector of the monitor (
in fi g. 3) and the other
end to the Line-Out connector of the computer.
Carefully lift the monitor out of the packaging and make
sure that all components are included (see fi g. 1).
Save the original box and packing material in case you
have to ship or transport the monitor.
To set up the device, you must fi t the monitor base
together. You can adjust the height of the base. When the
base of the monitor is extended, you can tilt the monitor
90° (Pivot function).
UNPACKING
STARTUP
1. First start your PC and then turn on your Belinea
monitor using the power switch (
in fi g. 4). The
status indicator (
in fi g. 4) should light up green.
2. Adjust the image to meet your requirements (see the
following sections “Basic Setup” and “Image settings
using the OSD menu”).
3. If there is no image displayed on the monitor, consult
the section “Troubleshooting”.
Figure 1. Monitor with swivel base
CONNECTING
Figure 2a. Connecting the monitor to the PC
Figure 3. Connecting the monitor to the power source
Power cord
Audio cable
Signal cable
VGA cable
DVI-D cable
(optional)
Figure 2b. Connection via the DVI-D interface
1
2
D-SUB AUDIO IN
D-SUB AUDIO IN
D-SUB AUDIO IN
