Bedienungsanleitung Benekov R16 (Seite 15 von 41) (Englisch)

693642

Zoom out

Zoom in

Vorherige Seite

1/41

Nächste Seite

4.2. Control, regulating and security devices

The control and regulation of the boiler is ensured by the instruction control unit -

see separate service instructions.

Security elements that control the safe boiler running:

 Safety thermo regulator (safety switch) is used to prevent the heating

system from overheating. The safety switch is set from the producer to the top

temperature 95°C, i.e. to a higher temperature than the possible requested

temperature at the boiler.The safety thermo regulator is located under the front

panel on the console behind the instruction control unit.

 Thermal overload (motor protection) is a part of the fuel feeding device

drive and ensures the protection against burn off especially in the case when

the feed device is blocked. This element also disconnects the ventilator to

prevent the fire penetration to the container. During the regular operation,

the temperature of the engine can reach 85°C - such a temperature is not a

sign of breakdown.

 Turnstile is a device that mechanically separates the fuel in the container

from the fuel in the worm feeder. This technical solution ensures that if the fuel

in the worm feeder device burns up, there is no chance that the fire could

expand in the fuel container (especially in the case of long time power cut).

 Limit switch of the fuel container cover serves for the shut - down of the

worm feeder and the ventilator when the fuel container cover is opened. This

prevents running of the boiler when the fuel container cover is opened. After

correct closing of the cover the boiler is set up for further use.

 Emergency extinguishing system is noother security element that prevents

the burn up of the fuel back into the fuel container. When the temperature at

the bottom of the fuel container rises over 95°C the thermostatic valve is

opened and the bottom of fuel container is filled with water form the water

supply system or from the installed water pressure tank.

 Firing flap is placed among the second and third draught of the boiler in the

upper part of the lamella exchanger and enables to regulate the temperature

exiting exhausts.

During the boiler operation, when the temperature of exhausts raises over

100°C the firing flap must be closed, i.e. the cleaner and firing flap adjusting

handle on the side of the boiler must be turned in the downward direction

(towards the rear) and secured by means of the locking screw with plastic

head.

By firing (cold chimney) or during the long time minor load of the boiler it is

recommended to operate the boiler with the firing flap partly open to prevent

the exhaust temperature drop below 80°C. In this case it is necessary to turn

the cleaner and ignition handle in the upper direction (towards you) and secure

by means of the locking screw with plastic head.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Benekov R16 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info