Bedienungsanleitung Benekov S100 (Seite 23 von 30) (Englisch)

693646

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

7.1. Making fire in the boiler

1. Check the water volume in the heating system.

2. Check whether the stop valves between the boiler and the heating system are open.

3. Check the circulation pump/pumps functionality.

4. Clean the burner and bottom of the combustion chamber.

5. Fill the container with prescribed fuel - see Chap. 3. If the container is equipped with a lid,

close the container after refilling in order to avoid potential false air intake into the burner

through the screw feeding device.

6. Connect the boiler to the mains (400V/50Hz) via power cord with plug.

7. Put the control unit into operation (see separate control unit instruction manual).

8. If the boiler is equipped with automatic ignition, leave the boiler without intervention. The

control unit evaluates the status of the boiler and makes fire (see separate control unit

instruction manual). During the boiler firing and operation the door must be permanently

closed.

9. If the boiler is not equipped with automatic ignition, it is necessary to make fire manually

(see separate control unit instruction manual). Using the control unit manual mode deliver

the fuel into the combustion chamber of the boiler. Leave the screw feeder device switched

on until the fuel appears in the burner (1 cm below the edge of the grate). Subsequently

switch the screw off, place fire setting material on the fuel (eg. paper, dry wood chips,

PEPO, solid alcohol or other material intended for this purpose), ignite it switch on the fan

and let it flame up (approx 1-2 minutes). Then add a small amount of prescribed fuel with a

shovel to the fire setting. In the event that the fire is extinguished, repeat the manual firing

procedure. Close the door and let the fire flame up well (about 3-5 minutes).

7.2. Boiler operation

After fuel flame-up the boiler switches (see separate control unit instruction manual) to

automatic operation, which includes the fan, as well as cycling of the fuel screw feeder. The

control unit display visualizes the basic data regarding the boiler operation.

During a power outage (400 V, 50 Hz) the boiler control unit remembers its status and restores

to this when the power returns.

If the heating water temperature exceeds 95 °C, the emergency thermostat will respond to shut

down the boiler irrespective of the control unit. When you turn off the emergency thermostat

the control unit indicates overheating.

The emergency thermostat can be switched on only when the temperature falls below the set

value by about 20 °C. This is done by unscrewing the black cap on the emergency thermostat

and pushing the colour button. The black cap must subsequently be restored to its place.

To prevent unwanted switching of the safety thermostat due to the thermal inertia of the boiler,

it is recommended to operate the boiler at outlet heating water temperatures up to 80 °C.

In case of repeated switching off of the boiler by the emergency thermostat, the boiler must be

shut down and the user must determine the cause of the repeated overheating.

7.3. Boiler shutdown

Before the boiler is shut down, it is necessary to use manual screw feeder control to push the

hot fuel from the feed area of the boiler and burner into the ash tray drawer. This is not

necessary for short repairs when an operator is present.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Benekov S100 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info