693641
25
Zoom out
Zoom in
Vorherige Seite
1/39
Nächste Seite
25
The BENEKOV S16 and S26 boiler is connected to the chimney using a metal pipe with a diameter of
145 or 150 mm.
The BENEKOV S51 boiler is connected to the chimney using a metal pipe with a diameter of 200 mm.
Fuel placement:
Pellets are recommended to be stored in their original packaging from the manufacturer (PET bags or
"big bags") in a dry place.
Do not store fuel behind the boiler or store it next to the boiler within a distance shorter than 400 mm.
The manufacturer recommends keeping the min. distance between the boiler and fuel at 1000 mm or to
store the fuel in a different room away from the boiler.
The room where the boiler is installed must be provided with permanent intake and outlet of air for
combustion and ventilation. Air consumption of:
- BENEKOV S16 at nominal output is about 45 m
3
. h
-1
- BENEKOV S26 at nominal output is about 75 m
3
. h
-1
- BENEKOV S51 at nominal output is about 150 m
3
. h
-1
According to regulations, an authorized person must perform the connection of the heating system pipeline
or heater heating element pipeline.
NOTE: When connecting the boiler to the heating system the lowest point as close to the
boiler as possible must be equipped with a drain tap.
6. Commissioning of the boiler - instructions for contracted service
organizations
Commissioning can only be performed by a contracted service organization authorized to conduct
this activity.
6.1. Electric connection using via connectors
In the course of putting the boiler into operation there is no need to tamper with any electrical connection of
the boiler’s control unit. Wiring of electrical components of the boiler and peripheral devices (e.g. ash
remover, automatic ignition, etc.) is via the connectors, which allows for quick and easy disconnection from
(or connection to) the boiler control unit.
Depending on the variant and equipment the boiler may be fitted with connectors marked with the following
symbols:
- Fuel feed drive connector
- Fan connector
- Automatic ignition connector
- Ash remover connector
25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Benekov S51 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info