Bedienungsanleitung Benning MM 1.2 (Seite 24 von 169) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Türkisch, Schwedisch)

577341

Zoom out

Zoom in

Vorherige Seite

1/169

Nächste Seite



5.1.17 The BENNING MM 1-1/ 1-2/ 1-3 is equipped with a detector as voltage

indicator at its top side to localize earthed AC voltages.

6. Ambient conditions

- The BENNING MM 1-1/ 1-2/ 1-3 is intended for measurements under dry

ambient conditions,

- Maximum barometric height for measurements: 2000 m,

- Overvoltage category / installation category: IEC 60664-1/ IEC 61010-1 →

600 V category III; 1000 V category II,

- Contamination class: 2,

- Protection category: IP 30 DIN VDE 0470-1 IEC/EN 60529

IP 30 means: Protection against access to dangerous parts and protection

against solid impurities of a diameter > 2.5 mm, (3 – rst index).

No protection against water, (0 – second index).

- Operating temperature and relative air humidity:

For operating temperatures from 0 °C to 30 °C: relative air humidity less

than 80 %,

For operating temperatures from 31 °C to 40 °C: relative air humidity less

than 75 %,

For operating temperatures from 41 °C to 50 °C: relative air humidity less

than 45 %,

- Storage temperature: The BENNING MM 1-1/ 1-2/ 1-3 can be stored at

temperatures between - 15 °C and + 60 °C (air humidity of 0 to 80 %).

During storage, the battery should be removed.

7. Electricalspecications

Note: The measuring accuracy is specied as the sum of:

- a relative part of the measured value and

- a number of digits (i.e. counting steps of the last digit).

This measuring accuracy applies for temperatures from 18 °C to 28 °C and a

relative air humidity less than 80 %.

7.1 DC voltage ranges

The input resistance is 10 MΩ.

Measuring

range

Resolution Measuring accuracy

Overload

protection

200 mV 100 µV ± (0.5 % of the measured value + 2 digits) 1000 V

2 V 1 mV ± (0.5 % of the measured value + 2 digits) 1000 V

20 V 10 mV ± (0.5 % of the measured value + 2 digits) 1000 V

200 V 100 mV ± (0.5 % of the measured value + 2 digits) 1000 V

1000 V 1 V ± (0.5 % of the measured value + 2 digits) 1000 V

7.2 AC voltage ranges

The input resistance is 10 MΩ in parallel 100 pF.

Measuring

range

Resolution

Measuring accuracy *

within the

frequency range 50 Hz - 300 Hz

Overload

protection

200 mV 100 µV ± (2.0 % of the measured value + 5 digits) *

750 V

eff

2 V 1 mV ± (1.5 % of the measured value + 5 digits) 750 V

eff

frequency range 50 Hz - 500 Hz

20 V 10 mV ± (1.5 % of the measured value + 5 digits) 750 V

eff

200 V 100 mV ± (1.5 % of the measured value + 5 digits) 750 V

eff

750 V 1 V ± (1.5 % of the measured value + 5 digits) 750 V

eff

The measured value of the BENNING MM 1-1/ 1-2/ 1-3 is obtained by mean

value rectication and is displayed as r.m.s. value.

The measuring accuracy is specied for a sinusoidal curve. In case of non-

sinusoidal curves, the accuracy of the displayed value decreases. Thus, an

additional error results for the following crest factors:

Crest factor from 1.4 to 3.0 additional error ± 1.5 %

Crest factor from 3.0 to 4.0 additional error ± 3 %

Applies to sinusoidal curves of 50 Hz/ 60 Hz

For automatic range selection (AUTO), the change-over point might be al-

ready at a value of 1400!

09/ 2013

BENNING MM 1-1/ 1-2/ 1-3

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Benning MM 1.2 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info