Bedienungsanleitung Benno Pedelec - E-bike (Seite 25 von 72) (Englisch)

810831

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Battery wear

The battery can be charged approx-

imately 500 times. The battery ca-

pacity decreases during this time,

making the battery drain faster with the use

of the pedelec’s motor assistance. This does

not constitute a defect. Technically, this

counts as battery use. If the range is still suf-

cient, you can continue to use it

The battery life depends on various factors:

• The number of charging operations (about 500

charging cycles)

• The age of the battery

• Storing and Operating Conditions

Of course, your battery will deteriorate and ca-

pacity will be lost even if you do not use the bat-

tery.

The lifetime of your battery can be lengthened by

the following measures:

• Charging your battery after every ride, even

short trips. Lithium-ion batteries are not sub-

ject to a memory effect.

• Avoiding using high gears with high assistance

levels.

Charging the battery

You can usually charge your battery

both while it is mounted on the

pedelec and removed. Please read

the component manufacturer’s operating in-

structions in this regard.

Lithium-ion batteries are not subject

to a memory effect. You can re-

charge your battery at any time,

even after short trips.

Charge your battery at temperatures between 0 °C

and 45 °C (ideally at room temperature or 20 °C).

Do not charge the battery if it is still warm or hot

after intensive use. Give the battery sufcient time

before charging to reach this temperature.

Before charging, read the drive

manufacturer's instructions in the

system manual and on the charger.

Typical charging process

1. First insert the plug of the charging cable into

the charging socket on the battery, then the

plug the charger into a socket.

2. As soon as the charger is connected to the

power supply, a red LED will light up.

red

3. When charging is complete, the LED chang-

es from red to green. As soon as the battery

is fully charged, rst remove the plug from

the power outlet and wait until the LED on

the charger goes out. Only then should you

remove the plug from the battery.

green

Charging time depends on various factors. It can

vary greatly according to the temperature, age,

usage and capacity of the battery. Information

about your battery’s charging time can be found in

the technical information regarding your battery.

When the battery is fully charged, the charging

process is automatically terminated. Unplug the

plug from the battery and the power outlet.

Safety instructions

Only use the charger designed for

your battery.

Make sure you use the correct mains voltage.

The required mains voltage is indicated on the

charger. It must comply with the voltage of the

current source. Chargers marked 230V can also

be operated at 220 V.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Benno Pedelec - E-bike Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Benno Pedelec - E-bike

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info