780257
1
Zoom out
Zoom in
Vorherige Seite
1/2
Nächste Seite
REMIDEMI JUMP SEAT REAR RACK INSTALLATION
IMPORTANT: Notes to mechanic: See Instructions.
Install Benno RemiDemi Jump Seat Rear Rack
only on compatible Benno RemiDemi models.
Use only original hardware (included) and pre-
drilled holes and fittings. Do not mount Jump
Seat Rear Rack to damaged bikes. Do not modify
any parts or bikes, change position or drill new
holes as this will void any warranties and/or
claims for liability.
Step 1: Locate the two black rear rack cross bars
on your RemiDemi.
Step 2: Remove both cross bars by removing
the four nuts and bolts as shown in picture (2).
Save removed cross bars and hardware in case
you are planing to reinstall them in the future.
Step 3: Now install RemiDemi Jump Seat
Rear Rack by inserting all four barrel nuts into
the forward facing holes as shown in picture (3).
Rotate the slots of the barrel nuts into a vertical
position using a flat screwdriver.
Next place a large spacer on each of the four
small platform brackets before lowering rack
down as shown in picture (3).
Step 4: Now insert all four bolts (using the
small washers) from the bottom upwards
through the bracket (and large spacer) into the
rack as shown in picture (4). Carefully hand-
tighten each bolt until you can feel that it has
screwed into the barrel nut. Adjust position
of rack as needed before securely tighten all
four bolts.
Step 5: After installation, take a short test ride
in order to check for secure and tight fit and
ensure that everything works correctly.
Notes to owner: Periodically check to make sure
all bolts remain tight as usage and vibrations
may loosen them.
IMPORTANT:WHEN CARRYING PASSENGERS,
REAR WHEEL MUST BE COVERED!
INSTALL BENNO REMIDEMI WHEEL GUARDS,
SEAT PAD AND FOOT PEGS. FAILURE TO DO
SO COULD RESULT IN SERIOUS INJURY!
For Benno® RemiDemi EVO 1 (Steel Frame Only)
Compatible with:
- Benno City Pannier Bags (RemiDemi Pannier Plates needed)
- Benno RemiDemi Passenger Kit
- Most Racktime®/Snapit® accessories
- Single Yepp® EasyFit baby seat without adaptor
- Other side clamping baby seats (confirm with manufacturer)
- Ortlieb® Pannier Bags with 20mm adapter
(RemiDemi Pannier Plates needed)
Max load: 85lbs/40kg
Dimensions: Deck 18.5cm x 45cm (W x L)
Tubing diameter: 19mm (outside loop)
x4 x4
Hardware
x4 x1
READ CAREFULLY BEFORE INSTALLATION AND USAGE. TO BE INSTALLED
BY MECHANIC AT AUTHORIZED BENNO DEALER.
x4
Barrel
Nut Large
Spacer Small
Washer Bolt Rack
35mm Length
IMPORTANT:
35mm BOLT LENGTH
USE ONLY FOR REMIDEMI EVO 1
(STEEL FRAME)
1

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Benno RemiDemi EVO 1 - Jump seat rear rack wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Benno RemiDemi EVO 1 - Jump seat rear rack

Benno RemiDemi EVO 1 - Jump seat rear rack Zusatzinformation - Englisch - 2 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info