Bedienungsanleitung Beper 40110 (Seite 8 von 24) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

710720

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Nebulizer Use instructions

Disinfecting

All nebuliser components (except air hose) can be disinfected with chemical disinfectants following dosage and use limitations

as provided by disinfec tant manufacturer. Disinfectants are usually available at pharmacies.

Sterilizing with steam

All nebuliser components (except air hose and ma-sks) can be heat steam sterilized up to 121 °C (20 min.) or 134 °C (7 min.).

EN554/ISO11134.The sterilization packaging must conform to EN868/ISO11607 and be suitable for steam sterilization.

After sterilization always let all components cool down to ambient temperature before further use.

Do not repeat sterilization cycle when compo-nents are still warm.

MAINTENANCE, CARE, AND SERVICE

Order all spare parts from your dealer or pharmacis.

It is advisable replace nebulizer after some 100 to 120 treatments on single patient or after about 20 sterilization cycles. Check

the ﬁlter continually for cleanliness and repla-ce it if dirty, or after a maximum of 3 months use. Spare ﬁlters are provided with

the device. To replace the ﬁlter, open the air ﬁlter compartment 4 marked «Filter» and change the ﬁlter 11

MALFUNCTIONS AND ACTIONS TO TAKE

The device cannot be switched on

Ensure the power cord 2 is correctly plugged into the socket. Ensure the ON/OFF switch 3 is in the position «I». The device

has automatically switched off due to overheating. Wait until it has cooled down and try again.

The nebuliser functions poorly or not at all

Ensure the air hose 6 is correctly connected at both ends. Ensure the air hose is not squashed, bent, dirty or blocked. If necessa-

ry, replace with a new one. Ensure the nebuliser 5 is correctly assembled 12. Ensure the required medication has been added.

TECHNICAL DATA

Piston electrocompressor with thermal cut

Nominal voltage: see data label

Dimensions: 130x190x100 mm

Weight: 1.1 Kg approx.

Temporary use: 20/40 min I/O

MDD 93/42/EEC - Class of risk IIa

Maximum pressure: 185 kPa

Air ﬂow: 10 Lt/min

Noise level: 58 dBA (EN13544-1)

Neb rate: 0.35 ml/min (con soluzione NaCl0.9%)

Operating pressure: 60 kPa (0.6bar)

Operating ﬂow: 5 l/min

MMAD: 2.61 µm GSD: 2.75 Aerosol Output: 143 µl Output Rate: 87 µl/min

For any improvement reasons, Beper reserves the right to modify or improve the product without any notice.

The European directive (Dir. 2012/19/Ue-WEEE) on Waste Electrical and Elec-

tronic Equipment (WEEE), requires that old household electrical appliances must

not be disposed of in the normal unsorted municipal waste stream. Old appliances

must be collected separately in order to optimize the recovery and recycling of

the materials they contain, and reduce the impact on human health and the en-

vironment. The crossed out “wheeled bin” symbol on the product reminds you

of your obligation, that when you dispose of the appliance, it must be separately

collected.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Beper 40110 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info