Bedienungsanleitung Beper 90836 (Seite 10 von 32) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

710536

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Electric Tea pot Use instructions

BEFORE USING YOUR TEA KETTLE

If you are using the tea kettle for the rst time, it is recommended that you should clean your tea

kettle before use by boiling a full tea kettle of water twice, do not place tea and in the lter and then

discarding the water.

NOTE: the max capacity of tea kettle is 0.7L.

OPERATION OF YOUR TEA KETTLE

1. To ll the tea kettle, remove it from the power base and open the lid by pressing the open lid but-

ton, ll with the desired amount of puried water, and then close the lid. The water level should not

exceed MAX marks or sit below MIN level. Too little water will result in the kettle switching off before

the water has boiled.

NOTE: Do not ll the water over the maximum level, as water may spill out of the spout when boiling.

Ensure that the lid is rmly in place before plugging the power outlet.

2. Position the tea kettle on the power base.

3. Open the lid, take out lter, then put tea into the lter and place it back properly in the tea kettle,

and then close the lid.

4. Connect the plug into a power outlet. Turn on the switch by pressing it, the indicator will light up.

Then start to boil the water. You can shut off the power by turning off the switch at any moment du-

ring boiling water. If you want to boil water again, only turn on the switch directly to restart the kettle.

5. The thermostat will operate automatically once the water has boiled. If you do not turn off the

switch or unplug the power cord, when the temperature of water reduces, the thermostat will operate

again and boil the water again. The thermostat will cycle on and off to maintain the temperature of

water on the higher temperature.

6. If you want to serve the tea or coffee. Turn off the switch or unplug the power cord, and lift the tea

kettle from the power base and then pour the tea or coffee.

NOTE: operate carefully when pouring the tea from your tea kettle,as boiling tea or coffee will scald.

7. The tea kettle will not re-boil until the switch is pressed again. The kettle may be stored on the

power base when not in use.

Note: always disconnect the power supply when not use.

BOIL-DRY PROTECT

Should you accidentally let the tea kettle operate without water, the boil-dry protection will automa-

tically switch off the power. If this occurs, allow the tea kettle to cool before lling with cold water

and re-boiling.

CLEANING AND MAINTENANCE

Always disconnect the appliance from the power outlet and allow it to cool before cleaning.

1. Never immerse the tea kettle, power cord or power base in water, or allow moisture to contact

with these parts.

2. Wipe the appearance of body with a damp cloth or cleaner, never use a poisonous cleaner.

3. The lter can be immersed in the water for cleaning. And you can use the brush to clean the lter.

Before cleaning, discard the tea residue rstly.

CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the outside of the tea

kettle.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Beper 90836 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Beper 90836

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info