Bedienungsanleitung Beper BC040 (Seite 10 von 32) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

710515

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Electric Espresso Coffee maker Use instructions

HOW TO PREPARE THE COFFEE

1. Check that the coffee maker is cold, and then unscrew it by holding the boiler (C) with one hand and turning

the handle of the pitcher (B) anticlockwise with the other (Fig.1).

2. Remove the funnel lter (K).

3. To prepare 3 cups of coffee, ll the boiler (C) with fresh water until reaching the safety valve (J) that is visible

also inside the boiler (C),without exceeding it (Fig.2). To prepare 1 cup of coffee, ll the boiler with water up to

around 2 centimeters below the safety valve.

TIP: Use fresh and soft water. Salty or hard water will weaken the avor of coffee.

IMPORTANT: do not use the coffee maker without water in the boiler or alternatively using hot water for

faster operation.

4. Insert the funnel lter (K) in the boiler (C) ( Fig. 3). To prepare one cup of coffee, also insert the 1 cup lter

adapter (L) in the funnel lter (K) ( Fig. 4).

5. Fill the funnel lter (K) with ground coffee, without pressing it (Fig. 5). Fill it a little at a time to overlling.

6. Distribute the ground coffee uniformly and remove any excess coffee from the edge of the funnel lter.

IMPORTANT: Use good quality, medium-ground coffee for MOKA coffee makers. Do not use barley coffee

with this coffee maker.

7. Tighten the coffee maker securely, without exaggerating, holding the boiler (C) with one hand and turning the

pitcher clockwise with the other, without pushing on the handle.

8. Rest the coffee maker on the support base (F) ( Fig. 6) . Close the pitcher lid (A).

9. Press the on/off switch (Fig. 7) The coffee will start to be released from the tube (M) after a few minutes.

10. When coffee stops coming out, pour it into suitable cups and stir it well before serving.

Coffee preparation process will take about 4 to 5 minutes.

IMPORTANT: The rst time that the coffee maker is used, all the accessories should be washed with hot

water. Then make a few batches of coffee to throw away.

CLEANING AND MAINTENCE

1. Before performing the cleaning operations, wait for the coffee maker cool down after use.

2. Clean the inside of the tube (M) periodically.

3. Regularly check all the lters (D, K, L) and the gasket (E). Replace if there are signs of wear or deterioration.

Use original spare parts only.

4. Every so often check to make sure that the holes in all the lters (D, K, L) are not blocked; if necessary, clean

using a pin (Fig. 8).

5. Do not wash the coffee maker in the dishwasher.

6. When cleaning do not use solvents or abrasive detergents. Simply clean it with a sponge, keeping attention

not to wet the electrical parts.

7. When there is the necessity to remove and/or replace the disc lter (D) and the gasket (E), it’s important to

reinsert them properly in their respective place to avoid dangerous leakages of hot water.

Never rinse the boiler (C) under running water and never immerse it in water. Fig.3

TECHNICAL DATA:

Potenza: 400 W

Alimentazione: 220-240V ~ 50Hz

For any improvement reasons, Beper reserves the right to modify or improve the product without any

notice.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Beper BC040 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info