Bedienungsanleitung Beper BP630 (Seite 9 von 40) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

710252

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

USB rechargeable blender Use instructions

RECHARGE:

The plug for the USB cable is located on the base of the motor housing and is protected by a plastic cover, which

must be raised to insert the cable.

If the red light is on while turning on the appliance, it means that the battery is empty.

During charging the red light will ash until the charge is completed, when the charge is complete the light will

turn blue.

USAGE:

Before the rst use, clean the product as indicated in the paragraph “cleaning”.

Cut the ingredients into pieces of about 2 cm taking care to remove any very hard pits, shells and / or skin if the

ingredients are provided.

Put the ingredients in the container and make sure to add water and / or milk, taking care not to exceed the

maximum level (400 ml) indicated on the container. Failure to add liquid will affect the operation of the product.

Turning the motor housing upside down, screw it over the container.

Press the ON / OFF button and keep it pressed for about 3 seconds, until the blue light ashes, then the ap-

pliance starts to whisk, it is advisable to shake the blender during processing by holding it rmly, the light goes

off when the operation is nished.

Remove the motor body from the container then position the cover.

Note: After 4 consecutive work cycles, the operating light will start to ash, indicating that the product must be

switched off and let rest for at least 5 minutes to prevent the engine from overheating.

Warning: Before rst use, make sure the battery is fully charged.

CLEANING:

Fill the container with water, assemble the motor housing over the container and operate the product for about

20 seconds, the blades will be cleaned automatically. Dry carefully.

Take care that the blade is sharp.

The motor housing can be cleaned with a soft, slightly damp cloth.

TROUBLE SHOOTING :

Problem Possibile causes What to do

The appliance doesn’t work The product have been used for

too long time

The blade is blocked

The container is not well assem-

bled.

The battery is low power

Let the appliance rest for about

10 minutes than try again.

Remove the ingredients that block

the blades.

Try to assemble again.

Recharge the appliance .

The ingredients can’t be blended The container is too much or too

low loaded

The ingredients are too big or too

hard ;

Liquid has not been added

Pay attention to the min (100ml)

and max (400ml) levels shown on

the container.

Cut the ingredients in smaller

pieces.

Add water or other liquid.

The light ashes but the product

doesn’t work

Wrong assemble of the container

Low power battery

Container have been overloaded

Reassemble the container.

Recharge the battery.

Remove exceeding ingredients .

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Beper BP630 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Beper BP630

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info