784179
28
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
28
Maintenance
6005049_0 – 21.11.2019
6.3 Fault rectification
Possible faults are described below:
Description of the fault.
yPossible cause.
Remedy.
Fan and lighting do not work.
yNo power supply.
Check that the mains cable is connected on both
sides.
yThe breaker may have been tripped or is defective.
Check to see if the breaker has tripped.
If you use electric circuit breakers, turn the circuit
breaker on again.
For other types of fuse, consult a qualified electrician.
The fan does not work.
yThe device is not switched on.
Check all power levels.
D“4.2.1 Normal operation (page 20).
yThe device is connected to a window contact switch and
the window is closed.
Open the window.
yThe device is connected to a safety device. The safety
device detects a critical under-pressure.
Open a window.
Wait until the air pressure returns to normal.
The lighting does not work.
yThe device software requires a restart.
Interrupt the power supply for approx. 10 seconds.
yThe lamp has blown.
Please consult your dealer or customer services.
Smells occur during operation.
yThe filter filling is used up.
Change the filter filling.
D“6.2.2 Replacing filter filling (with recirculating and
hybrid mode)” (page 26).
Poor device performance.
yThe recirculated air filter is clogged.
Replace the filter filling of the recirculated air filter.
D“6.2.2 Replacing filter filling (with recirculating and
hybrid mode)” (page 26).
yThe hybrid filter is clogged.
Replace the filter filling of the hybrid filter.
D“6.2.2 Replacing filter filling (with recirculating and
hybrid mode)” (page 26).
yThe exhaust pipe was not properly connected or installed.
Please consult your dealer or customer services.
Control panel does not react after being touched several times.
yThe control panel is soiled.
Clean the control panel.
D“5. Cleaning” (page 24).
yThe device software requires a restart.
Interrupt the power supply for approx. 10 seconds.
Moisture in the device.
yDripping or splashing water has penetrated the device.
yLiquid (e.g. from vases, bottles on the device) has
penetrated the device.
Immediately shut off the power supply, by removing
the fuse.
Make sure that the power supply cannot be
unintentionally reconnected. For example by tasking
a person with ensuring that the fuse/breaker is not
restored/switched on.
Ensure that no more liquid can penetrate the device.
Allow the device to dry.
Have the device checked and repaired by qualified,
specialist personnel prior to using the device again.
If a fault persists:
Please consult your dealer or customer services.
28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Berbel BKH 110 GL-2 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Berbel BKH 110 GL-2

Berbel BKH 110 GL-2 Bedienungsanleitung - Deutsch - 32 seiten

Berbel BKH 110 GL-2 Bedienungsanleitung - Holländisch - 32 seiten

Berbel BKH 110 GL-2 Bedienungsanleitung - Holländisch - 32 seiten

Berbel BKH 110 GL-2 Bedienungsanleitung - Französisch - 32 seiten

Berbel BKH 110 GL-2 Bedienungsanleitung - Italienisch - 32 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info