Bedienungsanleitung Berbel BKH 80 ST (Seite 21 von 24) (Englisch)

784191

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Maintenance

6006262_0 – 03.06.2022

☞Unscrew the screws on the top of the filter.

☞Remove the cover.

☞Empty the filter completely.

☞Fill the filter with new charcoal up to the maximum level.

☞Screw the cover back on to the top of the filter.

☞Clean the filter from the outside (e.g. through extraction

with a vacuum cleaner).

☞Take hold of the filter at the handles.

☞Carefully insert the filter again.

☞Place the cover on the device.

☞Screw the cover tight again.

6.2.3 Fault rectification

Possible faults are described below:

Description of the fault.

yPossible cause.

☞Remedy.

The lighting does not work.

yThe device software requires a restart.

☞Interrupt the power supply for approx. 10 seconds.

yThe lamp has blown.

☞Please consult your dealer or customer services.

Fan and lighting do not work.

yNo power supply.

☞Check that the all-pole mains switch is connected.

☞Switch the mains switch on.

yThe breaker may have been tripped or is defective.

☞Check to see if the breaker has tripped.

☞If you use electric circuit breakers, turn the circuit

breaker on again.

☞For other types of fuse, consult a qualified electrician.

The fan does not work.

yThe device is not switched on.

☞Check all power levels.

D“4.2.1 Normal operation” (page 16).

yThe device is connected to a window contact switch and

the window is closed.

☞Open the window.

yThe device is connected to a safety device. The safety

device detects a critical under-pressure.

☞Open a window.

☞Wait until the air pressure returns to normal.

Smells occur during operation.

yThe filter filling is used up.

☞Change the filter filling.

D“6.2.2 Replacing filter filling” (page 20).

Poor device performance.

yThe recirculated air filter is clogged.

☞Replace the filter filling of the recirculated air filter.

D“6.2.2 Replacing filter filling” (page 20).

The smoke can settle on furniture, the fronts of kitchen units and

the ceiling.

ySmoke development by heating cooking oils and cooking

fats to too high a temperature.

☞Note the smoke point of the cooking oil or fat you

are using. You can obtain this information from the

respective manufacturer.

Control panel does not react after being touched several times.

yThe control panel is soiled.

☞Clean the control panel.

D“5. Cleaning” (page 18).

yThe device software requires a restart.

☞Interrupt the power supply for approx. 10 seconds.

Moisture in the device.

yDripping or splashing water has penetrated the device.

yLiquid (e.g. from vases, bottles on the device) has

penetrated the device.

☞Immediately shut off the power supply, by removing

the fuse.

☞Make sure that the power supply cannot be

unintentionally reconnected. For example by tasking

a person with ensuring that the fuse/breaker is not

restored/switched on.

☞Ensure that no more liquid can penetrate the device.

☞Allow the device to dry.

☞Have the device checked and repaired by qualified,

specialist personnel prior to using the device again.

If a fault persists:

☞Please consult your dealer or customer services.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Berbel BKH 80 ST Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Berbel BKH 80 ST

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info