779526
15
Zoom out
Zoom in
Vorherige Seite
1/63
Nächste Seite
ENGLISH ENGLISH
ROAD BIKE | OWNER’S MANUALOWNER’S MANUAL | ROAD BIKE
b ca e fd
| 2 8 2 9 |
NOTE!
I
The seating position depends highly on how you want to use the BERGAMONT
bike. Ask your BERGAMONT dealer or your trainer for help. The advice given below
is suitable for typical BERGAMONT road bikes.
NOTE!
I
If sitting on the saddle causes you trouble, e.g. because it numbs your crotch, this
may be due to the saddle. Your BERGAMONT dealer has a very wide range of
saddles available and will be pleased to advise you.
ADJUSTMENT OF THE SADDLE TO THE CORRECT HEIGHT
The correct saddle height depends on the length of your legs. When pedalling, the
ball of your foot should be positioned above the centre of the pedal axle. With your
feet in this position you should not be able to stretch your legs completely straight at
the lowest point, otherwise your pedalling will become awkward (d).
Check the height of your saddle with flat-soled shoes. This is best done with suitable
cycling shoes.
Sit on the saddle and put your heel on the pedal at its lowest point. Your leg should
be fully stretched and your hips should remain horizontal (e).
To adjust the saddle height loosen the quick-release lever (see the chapter “Using
quick-releases and thru axles“) or the binder bolt of the seat post clamp at the top
of the seat tube. The latter requires suitable tools, e.g. an Allen key, with which you
turn the bolt two to three turns anticlockwise. Now you can perform the vertical
adjustment of the seat post.
Be sure not to pull out the seat post too far – the mark on the seat post (f) (end, max.,
min., stop or the like) should always remain within the seat tube – and always grease
the part of an aluminium or titanium seat post that is inserted into a seat tube made
of aluminium, titanium or steel. Do not grease carbon seat posts and/or carbon seat
tubes in the clamping area! Use special carbon assembly paste instead.
ADJUSTING THE BERGAMONT BIKE TO THE RIDER
Your body height and proportions are decisive for the frame size of your BERGAMONT bike.
Make particularly sure there is enough space between your crotch and the top tube so that
you do not hurt yourself, if you have to get off your bike quickly (a).
By choosing a specific type of bicycle you roughly determine the posture you will be
riding in (b+c). However, some components of your BERGAMONT bike are especially
designed so that you can adjust them to your body proportions up to a certain
degree. This includes the seat post, the handlebars and the stem as well as the brake
levers/shifters.
As all works require know-how, experience, suitable tools and skills, you should
restrict yourself to adjusting your seating position. Contact your BERGAMONT dealer,
if you are not happy with your seating position or if you want something changed.
They will see to your wishes the next time you leave your BERGAMONT bike at the
workshop, e.g. for the first inspection.
After any adjustment/assembly work, be sure to make a short functional check
as described in the chapter “Tests before every ride” and do a test ride on your
BERGAMONT bike in an area free of traffic.
DANGER!
G
If you have a very small frame, there may be the danger of your foot colliding with
the front wheel. Therefore, make sure your cleats are properly adjusted.
DANGER!
G
All tasks described in the following require the know-how of a mechanic and
appropriate tools. Make it a rule to tighten the bolted connections always
with greatest attention. Increase the torque values bit by bit and check the fit of the
component in between. Use a torque wrench and never exceed the maximum torque
values! You will find the prescribed values in the chapter “Recommended torque
settings for your BERGAMONT bike”, directly on the components and/or in the manuals
of the component manufacturers.
15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

bergamont-road-bike-2019

Suche zurücksetzen

  • Hallo,
    wie stelle ich bei meinem E Bike Bergamont 500 8 Gang Nabenschaltung Baujahr 2019 die Fahrrad Kette richtig ein Eingereicht am 6-10-2023 19:46

    Antworten Frage melden
  • Hallo,
    wie stelle ich ich bei meinem E Bike Bergamont 500 8 Gang Nabenschaltung meine Fahrradkette ein Eingereicht am 6-10-2023 19:43

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bergamont ROAD BIKE 2019 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Bergamont ROAD BIKE 2019

Bergamont ROAD BIKE 2019 Bedienungsanleitung - Deutsch - 65 seiten

Bergamont ROAD BIKE 2019 Bedienungsanleitung - Französisch - 64 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info