Putting into Service7
See
Figure 2
The radio finger-scan is ready for operation immediately after the batteries have
been inserted.
To properly learn a fingerprint, the same finger must successfully be pulled over
the sensor three times.
NOTE:
To learn a fingerprint, the finger must be pulled over the sensor in the correct
position and with increased pressure (see Figure 3).
The first two learned fingerprints are the master fingers. Further finger prints (user
fingers) can only be learned using the master fingers.
NOTE:
After identification, the radio finger-scan will only send the radio code to open
and close a garage door or entrance gate if both master fingers have been
learned beforehand.
Assignment of a fingerprint to a radio code location7.1
The radio finger-scan has two radio codes preprogrammed at the factory. Before
learning a fingerprint, you can select the first radio code location or the second
radio code location using the PRG button. The learned fingerprint will then send
the stored radio code.
Learning the master fingers7.2
See
Figure 4
Learning the first master finger (M1)7.2.1
Push the cover up to the 1. second notch or press the ON button to activate the
device.
All LEDs will be illuminated and indicate the delivery condition.
Press the PRG button for at least 2.
5 seconds (selection of the a. first radio code location). The red and green
LEDs will go out and the blue LED slowly flashes for the duration of the
learning process.
10 seconds (selection of the b. second radio code location). The red and
green LEDs will go out and the blue LED slowly flashes in pairs for the
duration of the learning process.
18
TR20B001 RE / 07.2009
ENGLISH
