Bedienungsanleitung Bertazzoni P9101PROX P61V (Seite 10 von 41) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

612646

Zoom out

Zoom in

Vorherige Seite

1/41

Nächste Seite

USE AND MAINTENANCE MANUAL

DESCRIPTION OF HOBS

 GAS HOB TYPE P680, see Fig. 12 - Electrical Diagram A

 GAS HOB TYPE P910, see Fig. 13 - Electrical Diagram B

 GAS HOB TYPE P960, see Fig. 14 - Electrical Diagram B----

DESCRIPTIVE CAPTION FOR HOB CAPTION FOR ELECTRICAL DIAGRAM

(Figs. 12 13 14) (Diagrams A B)

1 Auxiliary burner 1 Electric panel

2 Semi-rapid burner 2 Lighter button

3 Rapid burner 3 Ignition device

4 Dual burner 4 Lighting plugs

5 Front left burner knob L Brown (phase)

6 Front right burner knob N Blue (neutral)

7 Back left burner knob ‘ ’ Yellow/Green (earth)

8 Back right burner knob

9 Central burner knob

10 Front central burner knob

11 Back central burner knob

USE OF THE BURNERS

On the control panel above every knob there is a diagram which indicates which burner the knob in question refers to. The burners can

be turned on in several ways according to the type of appliance and its individual features:

- Manual “On” switch ( this is always possible even if the electric current is cut off ): Turn the knob corresponding to the selected

burner in an anticlockwise direction so that the knob is at MAXIMUM (this corresponds to a large flame) and then put a lit match to the

burner.

- Electric “On” switch: Turn the knob corresponding to the selected burner in an anticlockwise direction so that the knob is at

MAXIMUM (this corresponds to a large flame) and then press the lighter button and let it go as soon as the burner is alight..

- Automatic Electric “On” switch: Turn the knob corresponding to the selected burner in an anticlockwise direction so that the knob is

at MAXIMUM (this corresponds to a large flame) and then press in the knob. Let it go as soon as the burner is alight.

- “On “ switch for burners with safety device ( thermocouples ): Turn the knob corresponding to the selected burner in an

anticlockwise direction so that the knob is at MAXIMUM (this corresponds to a large flame) and then use one of the lighting devices

described above. When the burner is lit keep the knob pressed in for about 10 seconds in order to allow the flame to heat up the

thermocouple. If the burner goes out when letting the knob go, repeat the operation all over again.

Use of the Dual burner (Fig.15)

This model controls both the central and the external crown of the burner with just one valve.

To ignite the central crown and the external crown of the burner, press and turn the knob to the maximum delivery position 1

and hold it down until ignition; in this position both the internal and the external flame are at maximum.

Turn the knob to position 2 to have the external crown at minimum and the internal crown at maximum flame

Turn the knob to position 3 to have the internal crown at maximum and the external crown off

Turn the knob to position 4 to have the internal crown at minimum and the external crown off.

N.B.: You are advised not to try and light a burner if its flame divider is not correctly in place.

Advice for the best use of the burners:

- Use suitable pans for each burner ( see tab. n° 4 and Fig. 16 ).

- When boiling point is reached turn the knob on to MINIMUM.

- Always use pans with a lid.

TABLE N°4: Recommended pan diameters.

BURNER

PAN DIAMETERS recommended (cm.)

Auxiliary

12 - 14

Semi-rapid

14 - 26

Rapid

18 - 26

Dual

22 - 26

ATTENTION: use containers with a flat bottom

ATTENTION: If there is no electric current you can light the burners with matches.

Lighting the burners with safety thermocouples can only be carried out when the knob is on MAXIMUM (large flame) .When

cooking food with oil or fat which can easily set alight, the user must not leave the appliance.

Do not use sprays near the appliance when it is in use. When using the burners make sure that the pan handles are in the

correct position. Keep children away. If the hob has a lid, before closing it, make sure that the surrounding work surface is

cleaned of any food that has been left there.

NOTE: The use of a gas cooking appliance produces heat and humidity in the place where it is installed. Therefore you need

to ensure that the place is well ventilated, keeping clear the natural ventilation openings (Fig. 4 ) and using the mechanical

ventilation device/ flue or electric fan ( Fig. 5A and 5B ). Intensive or prolonged use of the appliance may require additional

entilation such as by opening a window or an increased ventilation efficiency obtained by increasing the power of the

echanical ventilators if it is present.

CLEANING OF THE APPLIANCE

Before carrying out any cleaning operation disconnect the appliance from the electric mains and turn off the main tap which

supplies the appliance with gas.

Cleaning the worktop: Periodically the burner heads, enamelled steel grills, enamelled lids and flame dividers must be cleaned with

warm soapy water, rinsed and dried well.

Any liquid which overflows from the pan must always be removed with a cloth.

If opening or closing any tap is difficult do not force it but ask for an urgent check from the technical assistant.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bertazzoni P9101PROX P61V Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info