Bedienungsanleitung BeSafe IZI Twist i-size (Seite 4 von 102) (Alle Sprachen)

768212

Zoom out

Zoom in

Vorherige Seite

1/102

Nächste Seite

12 13

Guarantee

• Should this product prove faulty within 24 months of purchase due to

materials or manufacturing fault, except covers and harness straps,

please reTwist it to the original place of purchase.

• The guarantee is only valid when you use your seat appropriately and

with care. Please contact your retailer, they will decide if the seat will

be reTwisted to the manufacturer for repair. Replacement or reTwist

cannot be claimed. The guarantee is not extended through repair.

• The guarantee expires: when there is no receipt, when defects are

caused by incorrect and improper use, when defects are caused by

abuse, misuse or negligence.

• The child seat MUST NOT be installed in a front passenger

seat WITH AN ACTIVATED AIRBAG.

• The ﬂoor support must always be used. Make sure that the

ﬂoor support is fully pushed down and that the seat is positioned

horizontal with the spirit level in the middle.

• Never drive with a child in the seat if the seat is rotated to the side.

• Make sure the indicators are green before you drive.

! Warning: potential misuse

• Do take care when you remove the cover, as re-ﬁtting the cover is

done in reverse.

• The cover of the headrest can be taken o separately by

disconnecting the beads at the back and pulling o the fabric

towards the front.

Removing and reﬁtting the cover

1. Twist the seat towards the door while you pull the rotation release

handle upwards.

2. Check that the shoulder strap slots are level with your child’s

shoulders. (7)

3. While pressing the button of the central adjuster, pull the shoulder

straps away from the seat with a ﬂat hand. Make sure to pull the

straps evenly so that they stay at the same length. (8)

4. Open the harness buckle. (9)

5. The height of the shoulder straps and the headrest can be adjusted

by pulling the release handle upwards at the back of the headrest

and pulling the headrest up or down. (10)

6. Position the shoulder straps over the marking at the sides of

the seat to use the magnets to keep the harness open while you

position the child. (11)

7. When the child is positioned, place the shoulder straps over the

child’s shoulders and close the buckle: CLICK! (12)

8. Pull the harness strap through the central adjuster in the direction

of the arrow straight up/forwards. Continue pulling until the

harness is a comfortable but a ﬁrm ﬁt. (13)

9. Turn the seat against the driving direction before driving and check

if the release handles show green and the seat is locked into the

driving direction. (14)

Positioning of the child

1. To remove the seat from the vehicle, Twist the seat rear facing

and push the seat upwards while adjusting the ﬂoor support to its

shortest length.

2. Release the ISOﬁx connectors out of the seat by pushing down

the switch for the ISOﬁx connectors on both sides. Pull the

ISOﬁx release switch on both sides to disconnect from the ISOﬁx

car anchorage.

Removal of the seat from the vehicle

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BeSafe IZI Twist i-size Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info