2. Openings in the barrier should not allow passage of a 4-inch diameter
sphere.
3. Solid barriers, which do not have openings, such as a masonry or
stone wall, should not contain indentations or protrusions except for
normal construction tolerances and tooled masonry joints.
4. Where the barrier is composed of horizontal and vertical members and
the distance between the tops of the horizontal members is less than
45 inches, the horizontal members should be located on the swimming
pool side of the fence. Spacing between vertical members should not
exceed 1-3/4 inches in width. Where there are decorative cutouts,
spacing within the cutouts should not exceed 1-3/4 inches in width.
5. Where the barrier is composed of horizontal and vertical members and
the distance between the tops of the horizontal members is 45 inches
or more, spacing between vertical members should not exceed 4
inches. Where there are decorative cutouts, spacing within the cutouts
should not exceed 1-3/4 inches in width.
6. Maximum mesh size for chain link fences should not exceed 1-3/4
inch square unless the fence is provided with slats fastened at the top
or the bottom which reduce the openings to no more than 1-3/4
inches.
7. Where the barrier is composed of diagonal members, such as a lattice
fence, the maximum opening formed by the diagonal members should
be no more than 1-3/4 inches.
8.
through 7,and should be equipped to accommodate alocking device.
Pedestrian access gates should open outward, away from the pool,
and should be self-closing and have a self-latching device. Gates
other than pedestrian access gates should have a self-latching device.
Where the release mechanism of the self-latching device is located
less than 54 inches from the bottom of the gate, (a) the release
mechanism should be located on the pool side of the gate at least 3
inches below the top of the gate and (b) the gate and barrier should
have no opening greater than 1/2 inch within18 inches of the release
mechanism.
9. Where a wall of a dwelling serves aspart of the barrier
following should apply:
(a)
equipped with an alarm which produces an audible warning when
the door and its screen, if present, are opened. The alarm should
sound continuously for a minimum of 30 seconds within 7 seconds
after the door is opened.
UL2017 General-Purpose Signaling Devices and Systems, Section
77. The alarm should have a minimum sound pressure rating of 85
dBA
from other household sounds, such as smoke alarms, telephones,
and door bells. The alarm should automatically reset under all
conditions. The alarm should be equipped with manual means,
such as touchpads or switches, to temporarily deactivate the alarm
for a single opening of the door from either direction. Such
deactivation should last for nomore than 15 seconds. The
deactivation touchpads or switches should be located at least 54
inches above the threshold of the door
(b) The pool should be equipped with a power safety cover which
complies with
(c) Other means of protection, such as self-closing doors with
self-latching devices, are acceptable so long as the degree of
protection afforded is not less than the protection afforded by (a) or
(b) described above.
10. Where an aboveground pool structure is used as a barrier or where
the barrier is mounted on top of the pool structure, and the means of
access is a ladder or steps, then (a) the ladder to the pool or steps
should be capable of being secured, locked or removed to prevent
access, or (b) the ladder or steps should be surrounded by a barrier
which meets Section I, Paragraphs 1 through 9. When the ladder or
steps are secured, locked, or removed,any opening created should
not allow the passage of a 4-inch diameter sphere.
Section II: Barrier Locations
Barriers should be located so as to prohibit permanent structures,
equipment or similar objects from being used to climb the barriers.
Preparation
Installation of small swimming pool usually takes only 10 minutes with 1
people
Recommendations regarding placement of the pool:
• It is essential the pool is set up on solid, level ground. If the pool is set
up on uneven ground it can cause collapse of the pool and flooding,
causing serious personal injury and/or damage to personal property
Setting up on uneven ground will void the warranty and service claims.
• Do not set up on driveways, decks, platforms, gravel or asphalt. Ground
should be firm enough to withstand the pressure of the water; mud,
sand, soft / loose soil or tar are not suitable.
• The ground must be cleared of all objects and debris including stones
and twigs.
• Check with your local city council for by-laws relating to fencing, barriers,
lighting and safety requirements and ensure you comply with all laws.
Installation
Assembly can be completed without
tools.
NOTE: It is important to assemble
pool in the order shown below
assembly required.
1. Find solid, level ground and clear
it of debris.
Attention: Do not set up the pool
under cables or under trees.
2. Spread out the pool and make sure it is right side up.
3. Cover the water valve.
4. Inflate the top ring and close the air valve after inflation.
Note: Do not over inflate. Over inflation may cause damage.
5. Put 1’’
pool floor is slightly covered, gently smooth out all wrinkles. Start in the
center of the pool and work your way clockwise to the outside.
6. Continue to fill the pool until reaches the water fill line located on the
pool’s interior
pool for security reasons.
Dismantling the Pool
1. Open water valve on the bottom of the pool, water will drain
automatically
push down the wall of the pool to release the water
most of the water in 20 minutes.
Note: Drain by adult only!
2. Open the air valve on the top ring to deflate.
3. Air
A Do not leave the drained pool outside.
Repair
If your pool is damaged, use the provided repair patch.
1. Clean area to be repaired.
2. Carefully peel patch.
3. Press patch over area to be repaired.
4. Wait 30 minutes before inflation.
Pool Maintenance
W If you do not adhere to the maintenance guidelines covered
herein, your health might be at risk, especially that of your children.
1. Change the water of pools frequently (particularly in hot weather) or
when noticeably contaminated, unclean water is harmful to the user’s
health.
2. Please contact your local retailer to obtain chemicals to treat the water
in your pool. Be sure to follow the chemical manufacturer’s instructions.
3. Proper maintenance can maximize the life of your pool.
4. See packaging for water capacity
Cleaning and Storage
1.
Note: Never use solvents or other chemicals that may damage the
product.
2. Remove all the accessories and spare parts of the pool and store them
clean and dry
3. Once pool is completely dry
pool from sticking together
dry
4. Store liner and accessories in a cool, dry place out of children’s reach,
with a moderate temperature between 5°C / 41°F and 38°C / 100°F
5. During the rainy season, pool and accessories should be stored as
instructed above.
6. Unproper draining of the pool might cause serious personal injury
and/or damage to personal property
7. Check the product for damage at the beginning of each season and at
regular intervals when in use.
Parts:
Drawings may not reflect actual product, not scaled to size.
Liner
Underwater adhesive repair
patch
S-S-005842
2
