Bedienungsanleitung Bestway 57274 Fast Set (Seite 5 von 12) (Deutsch, Englisch, Holländisch, Französisch)

686832

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

POOL MAINTENANCE

Warning: If you do not adhere to the maintenance guidelines covered herein, your health might be

at risk, especially that of children. Pool water treatment is essential for the safety of the users.

Using chemicals inappropriately will cause property damage and personal injury.

NOTE: The pump is used to circulate the water and to filter small particles. In order to keep your

pool water clean and hygienic, you must also add chemicals.

1. It is recommended not to fill the pool with catchment water, drilling water, or drainage well

water: these waters generally contain polluted organic substances including nitrates and

phosphates. Filling pools with water from the public network is advised.

2. Always keep your pool clean and apply the correct pool chemicals. Unsanitary water is a

serious health hazard. It is recommended to use disinfectant, flocculant, acid or alkali chemicals

to treat your pool.

3. Clean the PVC liner regularly with non-abrasive brushes or a pool vacuum cleaner.

4. Throughout the season, the water filtration system must run long enough each day to clean the

entire volume of water in the pool.

5. Check the filter cartridge (or sand in a sand filter) regularly and replace dirty cartridges

(or sand).

6. Regularly check the screws, bolts and all the metal parts for rust. Replace if necessary.

7. If it rains, check that the water level is not higher than the specified level.

If water exceeds the specified levels, drain the pool to the specified level.

8. Do not use the pump when the pool is in use.

9. Cover the pool when not in use.

10. For pool water treatment, the pH value is very important.

ATTENTION: Do not leave the drained pool outside.

The following parameters ensure good quality water

0°

ATTENTION: Do not leave pool unattended while filling with water.

Pool walls will rise as you fill with water.

1. Fill pool until water capacity is 80%, DO NOT OVERFILL as this could cause the pool to

collapse. In times of heavy rainfall you may need to empty some of the water to ensure the

level is correct.

2. When filling the pool is completed, check that the water is not collecting on any side to ensure

the pool is level.

IMPORTANT: If pool is not level, drain water and re-level ground by digging out. Never attempt

to move the pool with water in it, serious personal injury or damage to the pool may result.

WARNING: Your pool may contain a great deal of pressure. If your pool has any bulge or

uneven side, then the pool is not level, the sides may burst and the water may discharge

suddenly causing serious personal injury and/or damage to property.

Parameters Values

Water clarity clear view of the pool bottom

Colour of the water no colour should be observed

Turbidity in FNU/NTU max. 1,5 (preferably less than 0,5)

Nitrate concentration above that of fill water in mg/l max. 20

Total organic carbon (TOC) in mg/l max. 4,0

Redox potential against Ag/AgCI 3,5 m KCl in mV min. 650

pH value 6,8 to 7,6

Free active chlorine (without cyanuric acid) in mg/l 0,3 to 1,5

Free chlorine used in combination with cyanuric

acid in mg/l

1,0 to 3,0

Cyanuric acid in mg/l max. 100

Combined chlorine in mg/l max. 0,5 (preferably close to 0,0 mg/l)

Repair

Check pool for any leaks from valves or seams, check the ground cloth for any evident water loss.

Do not add chemicals until this has been done.

NOTE: In the event of a leak, patch your pool using the underwater adhesive repair patch

provided.

Refer to the FAQs for further information.

Dismantling

1. Unscrew the drain valve cap counter-clockwise and remove.

2. Connect the adaptor to the hose and put the other end of the hose in the area where you are

going to drain your pool. (Check local regulations for drainage by-laws).

3. Screw the control ring of the hose adaptor clockwise onto the drain valve. The drain valve will be

open and water will start to drain automatically. Open the drain valve to the maximum position.

4. Deflate the top ring by squeezing the air valve.

5. When the top ring is fully deflated, press the top ring down, and tilt it to drain the pool easily.

Completely drain the water in the pool.

6. When draining is finished, unscrew the control ring to close the valve.

7. Disconnect the hose.

8. Screw the cap back onto the drain valve.

9. Air dry pool.

Storage and Winterization

1. Please remove all the accessories and spare parts of the pool and store them clean and dry.

2. Once pool is completely dry, sprinkle with talcum powder to prevent pool from sticking together,

fold pool carefully. If pool is not completely dry, mold may result and will damage the pool liner.

3. Store liner and accessories in a dry place with a moderate temperature between 5ºC / 41ºF and

38ºC / 100ºF.

4. During the rainy season, pool and accessories should be stored as per above instructions also.

5. Improper draining of the pool might cause serious personal injury and/or damage to personal

property.

6. We strongly recommend the pool is disassembled during the off season (winter months).

Store in a dry location out of children’s reach.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bestway 57274 Fast Set Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info