753194
5
Zoom out
Zoom in
Vorherige Seite
1/60
Nächste Seite
TROUBLESHOOTING GUIDE
PROBLEM
Remote Control is no longer
working
Too noisy / Jet water is
weak
No LED display
CAUSE
- The battery is on low power.
- The machine unit is not fully immersed in the
water.
- The machine is not parallel to the water
surface.
- Motor doesn't work properly.
- The transformer is unplugged or off.
- The transformer is not connected with the
machine.
- Display panel cord or display panel failure.
SOLUTION
- Contact your local Bestway Service Center
for instructions.
- Make sure the device is under the water.
- Check if the support plate is in place. Refer to
the “Installation” for details.
For assistance, please visit the support section
on our website, www.bestwaycorp.com.
- Ensure the transformer is plugged in and
switched on.
- Connect the transformer with the machine.
For assistance, please visit the support section
on our website, www.bestwaycorp.com.
Disposal
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with
your local authority or retailer for recycling advice.
Alarms
Fault alarm code Problem Solution
After the remote control emergency stop button is
pressed, the system is forced to enter the fault mode.
The motor stops running and the alarm prompts.
Motor idling and overload protection. If the motor is
no-load rotating or stalling, the operation current is too
large. The system enters the failure mode, the motor
stops running and the alarm prompts.
Motor failure.
Motor temperature is too high.
Signal problem between the control panel and PCB.
Input voltage is too low.
You can press the stop button to cancel the
fault or the system needs to be powered off
and turned back on to solve the fault.
Please check if the water level in the
swimming pool is lower than the bottom of
the motor impeller or if the motor impeller is
blocked.
Turn off the power, and restart after 30
minutes or after the water temperature has
cooled.
For assistance, please visit the support
section on our website,
www.bestwaycorp.com.
For assistance, please visit the support
section on our website,
www.bestwaycorp.com.
Please check if the voltage is within the
range required by the rating label.
5
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bestway 58517 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info