13
6 Initial use
You can operate the devices using disposable/rechargeable batteries, or using the power supply unit.
Camera
Battery operation
š Loosen the screw in the battery compartment lid and remove downwards.
š Insert four 1.5 V AAA batteries the correct way round.
š Close the battery compartment lid and screw it back on. The screw is a child safety feature.
Mains operation
š Using the power supply, connect the camera to a socket.
Now position the camera on the magnetic stand.
Monitor
Battery operation
š Slide down the battery compartment lid to the rear of the device.
š Insert the battery in the device the correct way round and close the lid.
Charging
The battery must be charged for at least three hours before the device can be first used independently of
the mains. During this time, you can begin using the device.
Whilst charging, the LED
Power
glows blue. As soon as the battery is fully charged, it glows red. When the
battery is low, the LED
Power
begins to flash. If the monitor is not charging, it shuts o automatically after
approx. 10 minutes.
If the devices are operated using the power supply unit and there is a power cut, the monitor switches to
battery operation. For this reason, the standby time is dependent on the battery charge status. If no bat-
teries were inserted in the camera, it switches o in the event of a power cut and there is an acoustic and
visual warning on the monitor, the LED
Link
flashes red.
7 Operation
š Position the camera so that it is in an elevated position and is not in proximity to any other devices that
may cause interference.
š Set the camera angle by turning the camera.
š Use the on/o switch to switch the camera on. The power LED of the camera lights up.
š Position the monitor in the room where you are, or use the belt clip to attach it to your belt if you are
outside for example.
š Switch on the monitor. The monitor's LED
Power
lights up.
š If the camera and monitor are outside of the maximum possible range, the LED
Link
glows green.
š If there is no connection between the devices (camera not switched on or outside of range), an
acoustic warning signal sounds, the message “OUT OF RANGE” appears on the display and
the LED
Link
flashes red.
ECO function
š Press the
ECO
button to activate ECO mode. You can find notes on this in section 4. The
ECO
LED
glows blue. Please note that in ECO mode the LED link goes o as transmission only takes place when
the baby is unsettled.
š If there is noise transmission, the display switches on automatically. If there are no further noises, it
switches o again automatically after approx. 30 seconds.
š To switch back to video surveillance, press the
ECO
button again. The display is activated and the
ECO
LED fades.
