Bedienungsanleitung Beurer IH 21 (Seite 16 von 72) (Deutsch, Englisch, Französisch, Italienisch, Spanisch, Polnisch, Türkisch)

568809

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Clean the device using a damp cloth, to which you can

apply a little detergent if necessary.

Do not use abrasive detergents and never immerse

the unit in water.

Important

•

Ensure that no water penetrates inside the unit!

•

Do not put the device or accessories in a dishwasher.

•

Do not touch the unit with wet hands while it is

plugged in; do not allow any water to be sprayed

onto the unit. The unit must be operated only when

it is completely dry.

•

Do not spray any liquids into the ventilation slots. Any

liquid that penetrates into the unit can damage the

electrical parts or other components of the nebuliser

and impair the function of the device.

Condensation, care of the hose

Depending on the environmental conditions, con-

densation may collect in the hose. To prevent against

bacterial growth and to ensure effective therapeutic

use, this moisture must always be removed. To remove

moisture from the hose, proceed as follows:

•

Remove the hose [8] from the atomiser [9].

•

Leave the hose plugged into the nebuliser [6].

•

Run the nebuliser until all the moisture has been dis-

placed by the flow of air.

•

In the event of significant contamination, replace the

hose.

Disinfection

Follow the steps listed below carefully in order to disin-

fect your atomiser and the accessories. It is advisable

to disinfect the individual components after the last

time they are used each day at the latest.

You can disinfect the IH 21 and its accessories in two

ways: using vinegar or boiling water.

First, clean the atomiser and accessories as described

in the “Cleaning” section. Then continue with the dis-

infection.

Disinfection using vinegar

•

Use a vinegar solution consisting of ¼ vinegar and ¾

distilled water. Make sure that the volume is sufficient

to fully submerse the parts, such as the atomiser,

mask and mouthpiece, in the solution.

•

Leave the parts in the vinegar solution for 30 minutes.

•

Then rinse the atomiser and the individual parts such

as the mask and mouthpiece with water.

Disinfection with boiling water

•

The atomiser should be taken apart and placed to-

gether with the mouthpiece and nosepiece in boiling

hot water for at least 10 minutes. Avoid the parts

coming into contact with the hot base of the pot.

•

You can also disinfect the atomiser, the mouthpiece

and the nosepiece with a standard vaporizer. Ob-

serve the manufacturer’s instructions for use for the

vaporizer when doing this.

Note

The face masks and air hose must not be placed in

hot water!

•

Carefully dry all components using a soft cloth.

•

We recommend disinfecting the masks using a retail

disinfectant.

•

Once all components are fully dry, reassemble the

atomiser and place the components in a dry, sealed

container.

Note

Please ensure that the parts are completely dried af-

ter cleaning, otherwise the risk of bacterial growth is

increased.

Drying

•

Place the individual components on a dry, clean and

absorbent surface and allow to dry completely (for

at least 4 hours).

Material resistance

•

As with all plastic components, frequent use and

cleaning of the atomiser and the accessories can

lead to a certain amount of wear. Over time, this can

alter the aerosol properties and may eventually affect

the efficiency of therapy. We therefore recommend

that you replace the atomiser once a year.

•

When choosing a cleaning or disinfecting agent, note

the following: Only use mild cleaning or disinfect-

ant agents in the quantities recommended by the

manufacturer.

Warehousing

•

Do not store the nebuliser in a damp atmosphere

(e.g. in the bathroom) or transport it together with

damp objects.

•

Store and transport the nebuliser away from direct

sunlight.

Storage

•

The accessories can be safely stored in the acces-

sories compartment [4]. Store the device in a dry

place, if possible in its original packaging.

9. Disposal

In the interest of environmental protection, do not dis-

pose of the device in household waste.

Please dispose of the device in accordance with

EC Directive – WEEE (Waste Electrical and Elec-

tronic Equipment).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Beurer IH 21 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Beurer IH 21

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info