Bedienungsanleitung Beurer IH 40 (Seite 19 von 80) (Deutsch, Englisch, Französisch, Italienisch, Spanisch, Polnisch, Türkisch)

568897

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

Disinfection with boiling water

Important

The facial masks and the hose must not be sub-

merged in hot water!

•

We recommend disinfecting the masks and hose

using commercially available alcohol-based disin-

fectant.

Note

•

The mouthpiece can be disinfected in boiling water

for 10 minutes.

•

Avoid touching the hot base of the pan in this

case.

•

You can also disinfect the mouthpiece using a

commercially available vaporiser. For more infor-

mation, please see the instructions for use of the

vaporiser manufacturer.

Drying

•

Dry the parts carefully using a soft cloth.

•

Place the individual parts on a clean, dry and ab-

sorbent surface and leave them to dry completely

(at least 4 hours).

Note

Please ensure that the parts are completely dried after

cleaning and disinfection before they are used again

or stored; otherwise the risk of bacterial growth is in-

creased.

Put the parts together again if these are completely

dry and place the parts in a dry, sealed container.

Durability of materials

•

The following point should be observed when se-

lecting the cleaning product or disinfectant: only

use a mild cleaning product or disinfectant in the

concentration and volume prescribed by the man-

ufacturer.

•

As with any plastic parts, atomisers and their ac-

cessories are affected by a certain amount of wear

and tear when used and hygienically prepared on a

frequent basis. Over time, this can lead to a change

in the aerosol, which can have a negative effect on

the efficiency of the therapy.

We therefore recommend that you replace the ac-

cessories after no more than a year.

Storage

•

Do not store in a room with a high level of dampness

(such as a bathroom) and do not transport with any

damp items.

•

When storing and transporting, protect from pro-

longed direct sunlight.

Troubleshooting

Problem/

question

Possible cause/remedy

The atom-

iser does not

produce any

aerosol or pro-

duces too little

aerosol.

1. No water in the water tank.

2. Insufficient amount of medication

in the atomiser.

3. Do not hold the atomiser vertically.

4. Unsuitable medication fluid filled

for nebulisation (e.g. too viscous –

viscosity must be less than 3).

The medication fluid should be pre-

scribed by the doctor.

The output is

too low.

Check whether the control dial for the

airflow is set correctly.

What medica-

tions are suit-

able for inhal-

ing?

Naturally, only your doctor can decide

which medication should be used for

treating your condition. Please con-

sult your doctor in relation to this

matter.

With the IH40 you can nebulise

medications with a viscosity of less

than 3.

There is inha-

lation solution

residue in the

medication

container.

This is normal and is necessary for

technical reasons. Stop the inhalation

as soon as you can no longer detect

nebulisation or the device switches off

automatically due to a lack of inhalant.

What should

be taken into

account when

using the de-

vice with ba-

bies and chil-

dren?

On babies, the mask should cover

the mouth and nose to ensure ef-

fective inhalation.

2. On children, the mask should also

cover both the nose and mouth. It is

not a good idea to carry out nebuli-

sation on someone who is sleeping,

as in this case not enough of the

medication will reach the lungs.

Note: Inhalation should only be car-

ried out under the supervision of an

adult and with their assistance and

the child should not be left alone.

Does inhala-

tion using the

mask take

longer?

This is necessary for technical rea-

sons. You breathe less medication

per breath through the holes of the

mask than via the mouthpiece. The

aerosol is mixed with ambient air via

the holes.

Should each

person have

their own at-

omiser?

Yes, this is absolutely essential.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Beurer IH 40 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Beurer IH 40

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info