Bedienungsanleitung Beurer IH 58 (Seite 21 von 96) (Deutsch, Englisch, Französisch, Italienisch, Spanisch, Polnisch, Türkisch)

715723

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

Disinfection

Please carefully observe the points below when disin-

fecting your atomiser and accessories. We recommend

disinfecting the individual parts on a daily basis after the

last usage as a minimum measure.

(All you need for this is a little white vinegar and distilled

water.)

•

First, clean the atomiser and accessories as described

in the “Cleaning” section.

•

Place the disassembled atomiser, mouthpiece and

nosepiece in boiling water for 5 minutes.

•

For the remaining accessories, use a vinegar solution

consisting of ¼ vinegar and ¾ distilled water. Make

sure that the volume is sufficient to fully submerse the

parts, such as the atomiser, mask and mouthpiece, in

the solution.

•

Leave the parts in the vinegar solution for 30 minutes.

•

Rinse the parts with water and dry them carefully with

a soft cloth.

Important

Do not boil or autoclave the compressed air hose or the

masks.

•

Put the parts together again when they are completely

dry and place them in a dry, sealed container.

Note

•

Please ensure that the parts are completely dried af-

ter cleaning, otherwise the risk of bacterial growth is

increased.

•

Use cold disinfection solution in accordance with the

manufacturer’s instructions.

Drying

•

Place the individual parts on a clean, dry and absor-

bent surface and leave them to dry completely (at least

4 hours).

Durability of materials

•

As with any plastic parts, atomisers and their accesso-

ries are affected by a certain amount of wear and tear

when used and hygienically prepared on a frequent ba-

sis. Over time, this can lead to a change in the aerosol,

which can have a negative effect on the efficiency of the

treatment. We therefore recommend that you replace

the atomiser and other accessories after a year.

•

The following point should be observed when selecting

the cleaning product or disinfectant: only use a mild

cleaning product or disinfectant in the concentration

and volume prescribed by the manufacturer.

Storage

•

Do not store in damp conditions (such as in a bathroom)

and do not transport with any damp items.

•

When storing and transporting, protect from prolonged

direct sunlight.

•

The accessories can be stowed securely in the ac-

cessory compartment. Store the device in a dry place,

ideally in the original packaging.

9. Disposal

For environmental reasons, do not dispose of the

device in the household waste.

Please dispose of the device in accordance with

EC Directive – WEEE (Waste Electrical and Electronic

Equipment). If you have any questions, please contact

the local authorities responsible for waste disposal.

10. Troubleshooting

Problem/

question

Possible cause/remedy

The atomiser

produces no

or too little

aerosol.

1. Too much or too little medication

in the atomiser.

Minimum: 2ml,

Maximum: 6ml.

Check nozzle for blockages.

Clean nozzle if necessary (e.g. by

rinsing out). Then start using the

atomiser again.

IMPORTANT: Carefully pierce the

fine holes from the underside of the

nozzle only.

3. Atomiser not held vertically.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Beurer IH 58 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info