Bedienungsanleitung Beurer JIH50 (Seite 15 von 76) (Deutsch, Englisch, Französisch, Italienisch, Spanisch, Polnisch, Türkisch)

533571

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

Assembly

Remove the unit from the packaging.

• If not already

fitted, fit the

mesh atomiser

(3) onto the

neck of the

container (2),

and lock into

place by turn-

ing it clock-

wise until the

silver-coloured

contact elec-

trodes are facing downwards.

•

Place the

container with

fitted mesh

firmly onto the

housing (6) or

base of the

device, so that

you hear it click

into place on the

left and right.

•

Insert the batter-

ies.

Inserting the batteries

•

To open the battery compartment (7) on the under-

side of the device, apply light pressure and pull the

battery compartment cover in the direction of the

arrows, then fold the lid up.

•

Insert four batteries (type AA LR6).

•

Ensure that the poles of

the batteries are

touching their

respective poles in the

device (see illustration

on the bottom of the

casing).

•

Fold the battery com-

partment lid down again

and push it back in

place, in the opposite

direction to the arrows.

Note

•

When changing batteries, ensure that the medicine

container is completely empty, otherwise there is a

risk of leaks.

•

When the orange LEDs (4) light up, replace all four

batteries, because spraying becomes much less

effective when the batteries are weak.

•

You can operate the device for approx. 180min-

utes with new alkaline batteries.

•

This is sufficient for 5 – 9 uses of saline solution

(depending on the dose and duration of each use).

Operating the device with the power pack

Only connect the power pack (13) to the mains voltage

listed on the type plate.

•

Open the battery compartment lid to connect the

power pack (13).

•

Insert the power pack connector (8) into the con-

nection socket provided (15), and the power pack

(13) fully into a suitable socket.

Note

•

Ensure that there is a socket near to where the unit

will stand.

•

Lay the mains cable in such a way that no one can

trip over it.

•

To disconnect the nebuliser from the mains after

use, first switch off the device and then remove the

plug from the socket.

•

Do not remove the batteries when operating the

device with the power pack (13).

•

The power pack (13) cannot be used for charging

batteries.

7. Operation

1. Preparing the atomiser

•

For reasons of hygiene,

it is imperative that the

atomiser and accompa-

nying accessories are

cleaned and disinfected

after every use.

If the therapy requires

that various different medicines be inhaled in suc-

cession, ensure that the atomiser is rinsed after

every use. For details, see Cleaning and disinfec-

tion on page 16.

•

Remove the cover (1) from the device.

. Filling the atomiser

•

Open the medicine container

(2) by opening the clip, and fill

the medicine container with

an isotonic saline solution or

medicine. Do not overfill! The

maximum recommended fill

amount is 8 ml.

•

Use medication only on the advice of a physician,

and check the appropriate inhalation duration and

quantity for your needs.

•

If the recommended dose of the medicine is less

than 2 ml, top up this quantity to at least 4 ml us-

ing only isotonic saline solution. Viscous medicines

may also require dilution. Always follow the in-

structions of your doctor.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Beurer JIH50 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Beurer JIH50

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info