715933
17
Zoom out
Zoom in
Vorherige Seite
1/84
Nächste Seite
17
5. Initial use
Unpacking the device
WARNING
Keep packaging material away from children. There is the risk of suffocation.
1. Open the cardboard packaging.
2. Remove the protective insert. Keep the plastic film closed.
3. Lift the device up and out of the packaging.
4. Remove the plastic covering.
5. Check the device, the mains plug and the cable for damage.
Installation location
WARNING
Read the safety notes before putting the device into operation.
Note
T
he immediate vicinity of the air humidifier can become damp.
C
alcareous water can leave white deposits.
D
o not place the device on the floor, but in a raised position (e.g. on a table or chest of drawers).
P
osition the device so that the mist outlet is not directed towards objects.
D
o not use the air humidifier in rooms with significant temperature variations since this could lead to
condensation inside the device.
E
mpty any remaining water when the device is not in use.
P
lace the air humidifier on a firm, level and water-resistant surface.
If the device should accidentally tip over, water may escape, even if the device is switched off and unplugged.
Water
Note
D
o not add any essential oils or fragrances to the water. If additives are used, the plastic material may
become discoloured and damaged. The ultrasound membrane gets stuck and is damaged.
U
se fresh drinking water in the device. If the drinking water is very hard, you can use demineralised or
distilled water.
U
se warm water (30°C-45°C) and always fill the tank to the maximum level, otherwise the device could
leak due to physical factors.
Tip! If the water is hard, we recommend using the optional anti-limescale filter.
Filling the water tank
1.
Remove the water tank from the base unit in an
upward direction.
2.
Turn the water tank over. The water tank is kept
closed by means of a spring valve.
3. Open the screw plug on the water tank.
4.
Fill the water tank with warm water (30°C-45°C).
The water tank holds a maximum of 4.0 litres. The
water level is visible from the outside.
5. Close the screw plug on the water tank tightly.
6. Turn the water tank over.
7. Place the water tank on the base unit.
Ensure that the water tank is sitting firmly on the
base unit.
17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Beurer LB 45 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info