715933
20
Zoom out
Zoom in
Vorherige Seite
1/84
Nächste Seite
20
8. Additional anti-limescale filter
TIP!
If the water is hard, we recommend using the anti-limescale filter (see section “12. Replacement items”).
Note
I
f the anti-limescale filter does not prevent limescale build-up, or if white deposits form on or in the
device, the anti-limescale filter should be replaced.
T
he service life of the anti-limescale filter is around 2 to 3 months at most.
I
f the device is not used for a relatively long time, the anti-limescale filter must be removed from
the water tank and dried out.
Fitting the anti-limescale filter
1. Ensure that the device is switched off.
2. Remove the water tank from the base unit in an upward direction.
3. Turn the water tank over.
4. Open the screw plug on the water tank.
5.
Screw the anti-limescale filter on the screw plug thread of the water tank.
6. Close the screw plug on the water tank. The anti-limescale filter is now
fitted.
9. What if there are problems?
Problem Cause Solution
No mist is produced The mains cable is not plugged in. Plug the mains cable into a suitable
socket.
The control dial is in the off
position.
Turn the control dial clockwise towards the
maximum position.
The water level is too low; the
water tank is empty.
Fill the water tank.
The mist has a strange
smell
The device is new. Lift up the water tank, turn the screw plug
and remove it. Air the open, empty water
tank in a cool, dry place for 12 hours.
Stale or dirty water. Empty the base unit and the water tank
and clean them thoroughly. Fill the water
tank with fresh water.
Strange noise The water tank is not positioned
correctly on the base unit.
Lift up the water tank and position it cor
-
rectly on the base unit. The tank should sit
tightly on the base unit.
There is too little water in the water
tank.
Fill the water tank.
The device is not level and unstable.
Place the device on a firm, level surface.
Mist escapes from
underneath the water
tank
The water tank is not positioned
correctly on the base unit.
Lift up the water tank. Check whether the
join between the base unit and water tank
is clean. Clean if required. Position the
water tank correctly on the base unit. The
tank should sit tightly on the base unit.
20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Beurer LB 45 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info