779862

Bianchi E-Omnia Seite 7

7
Zoom out
Zoom in
Vorherige Seite
1/47
Nächste Seite
12 13
EN EN
Before using the pedal-assist bicycle, check that the adjustment screws are tightened as indicated
near them. If there is any doubt about the adjustment, consult an authorized dealer.
2.4.3 HANDLEBAR
The height of the handlebar as well as its inclination can be adjusted by means of the corresponding
adjustment screws. The position of the screws and the modes may vary depending on the model:
EOMNIA MODEL TYPE EXAMPLE IMAGE OF HANDLEBAR ADJUSTMENT
SCREWS
OMNIA FX TYPE (FS) Velomann ST97
F:
Unscrew 1-2-3-4 to allow rotary movement
R:
1
3
2
4
E-OMNIA FT TYPE (FT) Velomann ST97
F:
Unscrew 1-2-3-4 to allow rotary movement
R:
1
3
2
4
OMNIA X TYPE (HT) Velomann ST97
F:
Unscrew 1-2-3-4 to allow rotary movement
R:
1
3
2
4
OMNIA T TYPE (Tourer)
Man
Velomann Catamaran
F:
Unscrew 1-2-3-4 to allow
rotary movement
R:
Unscrew 5 to allow rotary
movement
1
3
2
45
Velomann Fastback
F:
Unscrew 1-2-3-4 to allow rotary movement
R:
1
3
2
4
OMNIA T TYPE (Tourer)
Lady
Velomann Catamaran
F:
Unscrew 1-2-3-4 to allow
rotary movement
R:
Unscrew 5 to allow rotary
movement
1
3
2
45
Velomann Fastback
F:
Unscrew 1-2-3-4 to allow rotary movement
R:
1
3
2
4
OMNIA C TYPE
(City) Lady
Velomann Catamaran
F:
Unscrew 1-2-3-4 to allow
rotary movement
R:
Unscrew 5 to allow rotary
movement
1
3
2
45
Velomann Fastback
F:
Unscrew 1-2-3-4 to allow rotary movement
R:
1
3
2
4
Before using the pedal-assist bicycle, check that the handlebar is aligned with the front
wheel and that the adjustment screws are tightened as indicated near them.
If there is any doubt about the adjustment, consult an authorized dealer.
2.4.4 BRAKES
All E-OMNIA models are equipped with a disc brake system which can be operated by actuating the
two levers on the handlebar. The right-hand lever operates the rear brake, the left-hand lever operates
the front brake. The braking torque is proportional to the force applied to the levers. You can adjust the
inclination and position of the levers by loosening the lever locking screw.
Before using the pedal-assist bicycle, make sure that the screws securing the brake levers have been
tightened in accordance with the torque indicated on the screws. Adjustment of any other brake system
parameters is not recommended. If there is any doubt about the adjustment, consult an authorized
dealer. Do not touch the brake discs after braking, as they may be hot and this may result in burns.
2.4.5 PEDALS
The pedals must be tightened to the cranks. By applying torque to the pedals, it is possible to apply a
translational motion to the pedal-assist bicycle. All E-OMNIA models are equipped with electric pedal
assist, the motor is automatically activated once the pedal-assist bicycle is switched on and a torque
is applied to the pedals.
The user can fit and remove the pedals ensuring they are tightened to a torque of 22 to 25 Nm.
When assembling, pay attention to the direction of screwing of the pedals: the right-hand pedal
has a right-hand thread, the left-hand pedal has a left-hand thread.
Pedals other than those supplied can be mounted provided that they are in accordance with the laws
of the Country where the bicycle is used.
2.4.6 LIGHTS
All E-OMNIA models have an integrated front and rear lighting system. The reflectors supplied are
required by law in some countries. It is recommended to refer to the national and regional regulations
of the Country where the bicycle is used. Once the switch on button (4) is pressed, the front and rear
lights are switched on and off simultaneously using the control (3) shown in Figure 3 for E-OMNIA
T-Type (man and lady), C-Type, FT-Type models.
Once the switch on button is pressed, the front and rear lights are switched on simultaneously by
pressing and holding for an average time between 1 and 2.5 s the button (6) shown in Figure 4 for
E-OMNIA X-Type and FX-Type models. The lights are switched off by pressing the control (6) for more
than 2,5 s. The inclination of the light beam can be adjusted by means of the adjustment screw shown
in Figure 5.
Figure 5 - Front lamp adjustment
Figure 3 - Kiox light controls
1
2
3
4
17
6
Figure 4 - Purion light controls
7
62
3
4
5
… 7 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bianchi E-Omnia wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info