Bedienungsanleitung BionX D-series (Seite 9 von 17) (Englisch)

648008

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

16 17

Power Supply

48V battery charging procedure (power supply)

• Connect the power supply and the battery by

inserting the charge connector into the TOUCH PORT

– the BionX system can be on or off

• Connect the power supply to a power receptacle

• The battery TOUCH PORT (LED ring around the

charge connector) lights up red upon insertion and

then turns to amber during the charging process

• When fully charged, the colour of the LED ring

changes to green. The battery charging process is

then complete

• Following this procedure the charging connector should be disconnected from the battery

• During the charging process you can check the battery state-of-charge through the console if the

battery is connected to the system – a 48V system can be switched on while it is charging

This has my vote :)

Battery state-of-charge Colour

100-75 % Green

75-20 % Amber

< 20 % Red

Checking the 48V Battery state-of-charge

• Swipe your ﬁnger slowly over the TOUCH PORT

• Battery state-of-charge LED will illuminate

• Allow ten (10) seconds before checking state-of-charge again

NOTE

The power supply is suitable for line voltage ranges of 110-115V or 220-230V, and com-

pensates automatically. The 48V battery is designed to be charged by a 26V BionX power

supply. The battery has an integrated charger which permits the use of a small, portable

power supply.

Ensure that a completely charged battery is no longer connected to the power supply after the charge

procedure is completed.

TOUCH PORT green =

fully charged

TOUCH PORT amber =

charging

TOUCH PORT red =

upon insertion

It is best to store the battery in a cool location at temperatures between 10 °C (50 °F) and 25 °C (77 °F).

Never store the battery in locations where the temperatures can reach more than 45 °C (113° F) or

fall below -10 °C (14 °F). The battery should never be exposed to extreme temperature ﬂuctuations

or humidity, and always protect the battery during storage from humidity to prevent corrosion of the

connectors. Never drop the battery. Always protect it from physical damage. Damage may lead to short-

circuits, and as a result cause overheating of the battery.

Do not dispose of used batteries in regular household trash, be aware that used batteries

must be disposed of properly! BionX batteries can be returned to BionX to be recycled.

WARNING

The BionX power supply/charger should be used exclusively for BionX rechargeable

batteries of the speciﬁed type. Keep the power supply or charger away from water or

moisture when charging and/or connected to prevent electrical shock or short-circuits.

Do not use a power supply or charger that has obvious signs of damage to the cable,

housing, or the connector.

Extreme temperatures will affect battery life, especially during charging. Avoid charging in direct sunlight

or in very hot or cold temperatures as this will reduce the life of the battery considerably. We recommend

charging the battery at room temperature (approximately 20 °C / 68 °F). The battery should be warmed to

room temperature before it is charged, particularly if it was exposed to cold temperatures during a ride.

The battery can be charged when mounted on the bicycle or removed from the docking station.

A Lithium Ion battery does not have a memory effect, which means that the battery’s maximum energy

capacity is not affected if it is repeatedly recharged after only being partially discharged. The battery does

not need to be completely drained before charging. We recommend charging the battery after every ride,

preferrably when the state-of-charge display shows less than 50%. When the battery is fully depleted it will

signal that a recharge is needed by beeping. The battery is fully charged after approximately 4 to 5.5 hours.

CAUTION

All classic BionX batteries must be charged when not in use for a long period of time (i.e.

before winter storage) and then must be charged at minimum every three months. Not

charging the battery can lead to potential damage of the battery cells. This is a lack of

maintenance on behalf of the owner, which can incur a loss of warranty.

NOTE

New 48V BionX batteries are equipped with “Deep Sleep” mode, a function that preserves battery

energy depending on either the state of charge or signiﬁcant inactivity. A fully charged battery will

automatically enter Deep Sleep after 2 months, while a partially discharged battery will enter it in

increasingly faster time frames. This results in minimal energy consumption during standby and enables

a shelf life of up to 6 months for a fully discharged battery, and up to 18 months for a fully charged

battery. To activate a battery that has entered Deep Sleep mode, connect it to the 26V BionX power

supply and allow it to complete a full charge cycle. BionX still recommends charging these batteries at

minimum every 6 months.

english

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BionX D-series Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von BionX D-series

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info