Bedienungsanleitung Bischoff und Bischoff Centuro S7 (Seite 28 von 71) (Deutsch, Englisch, Französisch, Spanisch)

802030

Zoom out

Zoom in

Vorherige Seite

1/71

Nächste Seite

Bischoff & Bischoff GmbH |28.07.2020 - revision 3

5554

Centuro S7 | Scooter Scooter | Centuro S7

4.3. Driving the scooter

You should make your first journey on a level site with ample space

•Ensure that you are sitting correctly on your scooter. Set the speed

as low as possible. You can increase the speed when you are more

familiar with handling the scooter.

•To switch on your scooter, insert the ignition key into the ignition

lock on the control panel and turn the key a quarter turn to the

right.

•To switch off the scooter, turn the key a quarter turn to the left.

After getting out of the scooter, always ensure that you have

removed the ignition key and do not leave the scooter unattended

with the ignition key inserted.

•Please make sure that you do not have your hand on the forwards

/backwards lever when you switch on your scooter. This would

cause your scooter to display an error message. In this case, turn it

off and then on again to rectify this error.

•Pull back the speed selection lever on the right to move forwards

(Fig 22). The further you pull back the lever, the higher the speed.

The speed can go up to the maximum speed that has been preset

using the speed control. Release the lever to stop gently. Practice

these two procedures in order to get used to them.

•Steering is easy and works exactly like a bicycle in that you turn the

handlebars in the direction in which you wish to move. Leave plenty

of distance when you travel around a curve so that the rear wheels

are able to follow the path of the front wheels and so that you do

not cut across objects.

It is necessary to pay attention when reversing (fig 23). Ensure that

your speed is low before reversing. Please keep in mind that you need

to steer in the opposite direction when you are reversing. This requires

practice. Practice this also on a level site with ample space.

Please note that, for safety reasons, the reversing

speed is only half the speed going forward.

•If you turn sharply, turn the handlebars before you accelerate.

Always drive in a wide arc around corners and obstacles and ensure

that you drive slowly and carefully. For your own safety, the scooter

automatically reduces the speed when cornering.

•When the drive is connected, the brake is automatically applied

when the throttle lever is released. The scooter then cannot be

pushed or displaced because the brake is automatically applied to

the motor.

4.4. Pushing mode

If you want to push the scooter in certain situations, you must unlock

the brakes. It is easy to push the scooter in free wheel mode.

The electro-mechanical brake will then not operate.

•Pull the unlocking lever in the back (Fig 24) downwards.

•A small jerk will indicate that the drives are now unlocked.

•To lock, simply push the lever up and locking then takes place

automatically.

•The engine has a centrifugal clutch, the brake blocks automatically

should you accelerate the scooter too hard in overrun cutoff. Only

after a coming to a complete standstill will it be released.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bischoff und Bischoff Centuro S7 Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bischoff und Bischoff Centuro S7

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info