Bedienungsanleitung Black Decker BCHTS36 (Seite 9 von 96) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

725128

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

ENGLISH

(Original instructions)

Installing and removing the battery pack from the

appliance

Warning! Make certain the lock-off button is not engaged to

prevent switch actuation before removing or installing battery.

To install battery pack

Insert battery (8) into appliance until an audible click is heard

(Figure B). Ensure battery pack is fully seated and fully

latched into position.

To remove battery pack

Depress the battery release button as shown in Figure C and

pull battery pack out of appliance.

Assembly

Warning! Before assembly, remove the battery from the tool

t the blade sheath over the blades.

Warning! Before assembly, make sure that the tool is

switched off and unplugged and that the blade sheath is tted

over the blades.

Warning! Never use the tool without the guard.

Fitting the guard and bail handle (g. D–F)

Warning! Only use the tool with the guard and handle

properly assembled. Using the hedge trimmer without the

proper guard or handle provided may result in serious injury.

Note: The hedge trimmer was shipped with the guard and bail

handle attached to the hedge trimmer with a plastic tie.

u Cut the plastic tie.

u Remove the partially inserted screws from the body of the

tool (Fig. D).

u Slide the guard (5) onto the front of the hedge trimmer

housing (Fig. E).

u Insert two screws into the openings on the side of the

guard, tighten securely.

u Slide the bail handle (6) onto the front of the trimmer

housing behind the guard as shown in Figure F.

u Insert the remaining four screws into the openings on the

sides of the bail handle and tighten securely.

Use

Warning! Let the tool work at its own pace. Do not overload.

Switch

u To turn the unit on, push the lock off button (2) down,

squeeze the trigger (1) as shown in gure G. Once the

unit is running, you may release the lock-off button.

In order to keep the unit running you must continue to

squeeze the trigger.

u To turn the unit off, release the trigger.

Warning! Never attempt to lock a switch in the ON position.

Trimming instructions

u Maintain proper footing and balance and do not overreach.

Wear safety goggles, non-skid footwear when trimming.

u Hold the unit rmly in both hands and turn the unit ON.

u Always hold the trimmer, as shown in the illustrations in

this manual, with one hand on the switch handle and one

hand on the bail handle (gure H).

u Never hold the unit by the blade guard.

Trimming new growth (Fig. I)

u A wide, sweeping motion, feeding the blade teeth through

the twigs is most effective.

u A slight downward tilt of the blade, in the direction of mo-

tion gives the best cutting.

Warning! Do not cut stems greater than 19mm. Use the

trimmer only for cutting normal shrubbery around houses and

buildings.

Level hedges (Fig. J)

u To obtain exceptionally level hedges a piece of string can

be stretched along the length of the hedge as a guide.

Side trimming hedges (Fig. k)

u Hold the trimmer as shown and begin at the bottom and

sweep up.

Saw blade (Fig. M, N)

For branches too large for the blade ( 7 ) to cut, use the saw

blade (9 ). Position the saw blade as close to the bottom of

the branch as possible. Place the saw blade shoe against

the branch. Turn the hedge trimmer on as described above,

allowing the tool to work at its own pace until the branch is

fully cut.

POWERCOMMAND

u If you encounter a jam, depress the POWERCOMMAND

button (4) shown in Figure L. The blades will move back

and forth in a slower, more forceful rhythm to help cut

through difcult branches. Release the button to return to

normal hedge trimming usage.

Note: Once the button is released, the blades will immediately

return to full speed.

Note: The blades will stop when the button is held for 15

seconds. To reengage the POWERCOMMAND feature,

release the button and depress it again.DO NOT continuously

hold the POWERCOMMAND button during normal hedge

trimming.

Maintenance

Your BLACK+DECKER corded/cordless appliance/tool has

been designed to operate over a long period of time with a

minimum of maintenance.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker BCHTS36 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info