Bedienungsanleitung Black Decker BD BB226 (Seite 4 von 56) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

452270

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

ENGLISH

Chargers

Your charger has been designed for a specific voltage.

Always check that the mains voltage corresponds to the

voltage on the rating plate.

Warning! Never attempt to replace the charger unit with

a regular mains plug.

X Use your Black & Decker charger only to charge the

battery in the appliance/tool with which it was supplied.

Other batteries could burst, causing personal injury and

damage.

X Never attempt to charge non-rechargeable batteries.

If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service

Centre in order to avoid a hazard.

X Do not expose the charger to water.

X Do not open the charger.

X Do not probe the charger.

X Do not cover the charger.

The appliance/battery must be placed in a well ventilated

area when charging.

The following symbols are found on your charger:

Electrical safety

X If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service

Centre in order to avoid a hazard.

Features

This appliance includes some or all of the following features:

1. Flexible hook

2. LED light bar

3. Battery status LED

4. On/off/brightness switch

5. Charging socket

6. Mains charging adaptor

7. Charger jack plug

Use

Charging the light bar (fig. A)

X Insert the charger jack plug (7) into the charging

socket (5).

X Insert the mains charging adaptor (6) into a mains

power socket.

X The red battery status LED (3) will light to show that

the battery is charging.

X Do not charge for more than 40 hours.

X Remove the mains charging adaptor (6) from the

charging socket (5).

X After charging, wait for 5 minutes before using the

light bar.

Using the flexible hook (fig. B and C)

X The flexible hook (1) may be used to store, support or

suspend the light bar.

X The flexible hook allows the light bar to be set in any

position (fig. B).

X Make sure that the flexible hook is secure around the

supporting object.

Operating the light bar

X Press the on/off/brightness switch (4) once for the high

brightness setting.

X Press the on/off/brightness switch (4) again for the low

brightness setting.

X To turn the light bar off, press the on/off/brightness

switch (4) a third time.

Your charger is double insulated; therefore

no earth wire is required.

Fail-safe isolating transformer. The mains supply is

electrically separated from the transformer output.

The charger automatically shuts off if the

ambient temperature becomes too high.

As a consequence the charger will be inoperable.

The charger must be disconnected from the

mains supply and taken to an authorised service

centre for repair.

The charger is intended for indoor use only.

The charger is double insulated; therefore no earth

wire is required. Always check that the power supply

corresponds to the voltage on the rating plate.

130

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker BD BB226 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info