Bedienungsanleitung Black Decker BDV080 (Seite 6 von 72) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch)

53623

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

ENGLISH

X Remove the nuts from the bolts of the battery terminal's

connectors (fig. B).

X Install the red ring terminal (4) to the bolt of the positive

battery terminal connector and replace the nut.

X Install the black ring terminal (4) to the bolt of the negative

terminal connector and replace the nut.

X Insert the ac plug of the battery charger into an ac mains

socket.

Connecting the appliance with the dc accessory plug

(fig. A)

Warning! Always disconnect the ac plug from the ac mains

socket before connecting or disconnecting the appliance to or

from the battery.

X Connect the dc accessory plug (5) to the battery charger

with the in-line connector (6).

X Insert the dc accessory plug (5) into the vehicle's dc

accessory outlet.

X Insert the ac plug of the battery charger into an ac mains

socket.

Charging Indicators

The appliance has three charging indicators (2):

X Red LED - bad connection, the battery is not able to accept

charge or a reverse polarity connection has been detected.

X Yellow LED - good connection and the battery is charging.

X Green LED - the battery is fully charged.

When the appliance is properly connected, the yellow LED

will illuminate, indicating that the smart circuit is functioning

to assess the status of the battery. This procedure may take

up to 2 minutes if the battery voltage is lower than

12.8 Volts.

The appliance is fully automatic; it will power on when

needed and power off when the battery is fully-charged.

The appliance has built-in circuit protection which guards

against overcharging or short circuits.

Charging the battery (fig. C)

X Slide the charge rate selector switch (1) to the 1A or 2A

position as required.

X Leave the appliance on.

X Monitor the battery from time to time.

Note: A clicking sound may occur during the charging

process, this is normal.

X When the green LED is lit, the battery is fully charged, slide

the charge rate selector switch (1) to the 0 position.

X Remove the ac plug from the ac mains socket.

X Remove the charging leads from the battery.

Troubleshooting

If the appliance is not charging:

X Check that the battery charger is properly connected to a

live 230 Vac outlet (the yellow LED will illuminate).

X Check that the correct charging rate has been selected for

the battery being charged.

X If the voltage of the battery to be charged has fallen below

4 Volts, the battery cannot be charged with this battery

charger.

Maintenance

X Your Black & Decker appliance has been designed to

operate over a long period of time with a minimum of

maintenance. Continuous satisfactory operation depends

upon proper care and regular cleaning of your appliance.

Warning! Before performing any maintenance or cleaning on

the appliance, unplug the appliance.

X From time to time wipe the appliance with a damp cloth. Do

not use any abrasive or solvent-based cleaner. Do not

immerse the appliance in water.

Replacing the fuse in the dc accessory plug

X Remove the gold cap by turning it counter clockwise.

X Remove the rubber washer, centre pin and the spring.

X Remove the fuse.

X Fit a new fuse of the same type and size (5 A).

X Install the centre pin, spring and rubber washer.

X Install the gold cap by turning it clockwise onto the plug.

Protecting the environment

Should you find one day that your appliance

needs replacement, or if it is of no further use to

you, think of the protection of the environment.

Black & Decker repair agents will accept old

Black & Decker tools and ensure that they are

disposed of in an environmentally safe way.

Separate collection of used products and

packaging allows materials to be recycled and

used again. Re-use of recycled materials helps

prevent environmental pollution and reduces the

demand for raw materials.

Local regulations may provide for separate collection of

electrical products from the household, at municipal waste

sites or by the retailer when you purchase a new product.

Black & Decker provides a facility for the collection and

recycling of Black & Decker products once they have reached

the end of their working life. To take advantage of this

service please return your product to any authorised repair

agent who will collect them on our behalf.

You can check the location of your nearest authorised repair

agent by contacting your local Black & Decker office at the

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker BDV080 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Black Decker BDV080

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info