Bedienungsanleitung Black Decker CD14C (Seite 4 von 64) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

472966

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

ENGLISH

◆ When disposing of batteries, follow the instructions given

in the section “Protecting the environment”.

◆ Under extreme conditions, battery leakage may occur.

When you notice liquid on the battery, proceed as follows:

- Carefully wipe the liquid off using a cloth. Avoid skin

contact.

- In case of skin or eye contact, follow the instructions below.

Warning! The battery fluid, a 25-30% solution of potassium

hydroxide, can be harmful. In case of skin contact, immediately

rinse with water. Neutralise with a mild acid such as lemon

juice or vinegar. In case of eye contact, rinse abundantly with

clean water for at least 10 minutes. Consult a physician.

Fire hazard! Avoid short-circuiting the contacts of a

detached battery (e.g. when storing the battery in a

toolbox).

Do not incinerate the battery.

Do not attempt to charge damaged batteries.

Chargers

◆ Use your Black & Decker charger only to charge batteries

of the type supplied with your tool. Other batteries could

burst, causing personal injury and damage.

◆ Never attempt to charge non-rechargeable batteries.

◆ Have defective cords replaced immediately.

◆ Do not expose to water.

◆ Do not open the charger.

◆ Do not probe the charger.

The charger is intended for indoor use only.

Electrical safety

Your charger is double insulated; therefore no earth

wire is required. Always check that the mains voltage

corresponds to the voltage on the rating plate.

Never attempt to replace the charger unit with a

regular mains plug.

Features

This tool includes some or all of the following features.

1. Variable speed switch or two-speed on/off switch

2. Forward/reverse slider

3. Mode selector / torque adjustment collar

4. Chuck

5. Battery

6. Battery release button

Fig. D & E

7. Charger

8. Charging base

9. Charger connector

10. Charger plug

Assembly

Fitting and removing the battery (fig. A)

◆ To fit the battery (5), line it up with the receptacle on the

tool. Slide the battery into the receptacle and push until

the battery snaps into place.

◆ To remove the battery, push the two release buttons (6)

simultaneously while at the same time pulling the battery

out of the receptacle.

Fitting and removing a drill bit or screwdriver bit (fig. B)

Warning! First remove the battery from the tool.

This tool is fitted with a keyless chuck to allow for an easy

exchange of bits.

◆ Lock the tool by setting the forward/reverse slider (2) to

the centre position.

◆ Open the chuck by turning the front part (11) with one

hand while holding the rear part (12) with the other (fig. B).

◆ Insert the bit shank (13) into the chuck.

◆ Firmly tighten the chuck by turning the front part (11) with

one hand while holding the rear part (12) with the other.

Removing and refitting the chuck (fig. C)

◆ Open the chuck as far as possible.

◆ Remove the chuck retaining screw by turning it clockwise

using a screwdriver.

◆ Tighten an Allen key (14) into the chuck and strike it with

a hammer as shown.

◆ Remove the Allen key.

◆ Remove the chuck by turning it counterclockwise.

◆ To refit the chuck, screw it onto the spindle and secure it

with the chuck retaining screw.

Use

Charging the battery

The battery needs to be charged before first use and whenever

it fails to produce sufficient power on jobs that were easily

done before. A new battery, or a battery that has not been

used for an extended period of time, achieves full performance

only after approx. 5 charging and discharging cycles.

The battery may become warm while charging; this is normal

and does not indicate a problem.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker CD14C Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info