Bedienungsanleitung Black Decker FSM1610 T1 (Seite 5 von 56) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

586609

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

ENGLISH

(Original instructions)

Removing the carpet glider (Fig. G) (FSM1620 Only)

Caution! Always wear suitable shoes when changing the

carpet glider on your steam mop. Do not wear slippers or

open toed footwear.

u Return the handle (4) to the upright position and turn the

steam mop ‘OFF’.

u Place the steam mop on the resting mat and wait until it

cools down. (approximately ve minutes)

u Place the front of your shoe onto the carpet glider removal

tab (15) and press down rmly.

u Lift the steam mop up off the carpet glider (11).

Caution! Always place the steam mop on the resting mat (7)

with the handle (4) in the upright position when stationary and

make sure the steam mop is turned off when not in use.

Use

Important! This unit will kill 99.9% of bacteria & germs when

used in accordance with this manual and with the micro bre

pad tted and a continuous run time of 90 seconds.

Switching on and off

u To switch the appliance on, press the ON/OFF button (1).

It takes approximately 15 seconds for the steam mop to

heat up.

Note: When the steam mop is rst turned on the water res-

ervoir will glow red. Once the steam mop is ready to use the

water reservoir will glow blue.

u To switch the appliance off, press the ON/OFF button (1).

Caution! Never leave the steam mop in one spot on any

surface for any period of time. Always place the steam mop on

the resting mat (7) with the handle (4) in the upright position

when stationary and make sure the steam mop is turned off

when not in use.

Caution! Always empty the steam mop after use.

Note: When rst lled or after running dry it can take up to 45

seconds for steam to be produced.

Autoselect

Technology

This steam mop is tted with an Autoselect

dial (2) which

shows various cleaning applications. They are used to select

the correct operating mode for your particular cleaning opera-

tion.

Using the Autoselect

dial (2), choose from one of the follow-

ing applications:

Wood/Laminate

Stone/Marble

Tiles/Vinyl

The steam mop will select the correct volume of steam

required for your particular cleaning operation.

Note: Always check you are using the correct setting before

using your steam mop.

Hints for optimum use

General

Caution! Never use the steam mop without rst attaching a

cleaning pad.

u During use you can use the cable management clip (10) to

keep your cable out of the way of the work area..

u Always vacuum or sweep the oor before using the steam

mop.

u The easiest way to use the machine is to tilt the handle to

a 45˚ angle and clean slowly, covering a small area at a

time.

u Do not use chemical cleaners with your steam mop. To

remove stubborn stains from vinyl or linoleum oors, you

can pre-treat with a mild detergent and some water before

using the steam mop.

Steam cleaning

u Place a cleaning pad (6) on the oor with the ‘hook & loop’

side facing up.

u Raise the steam mop off the resting mat (7) and lightly

press it down onto the cleaning pad (6).

u Place the steam mop on the resting mat.

u Connect the steam mop to the mains.

u Turn the Autoselect

dial (2) to the required setting.

u Press the ON/OFF button (1). It takes approximately 15

seconds for the steam mop to heat up.

u Pulling the handle (4) back will activate the steam pump.

After a few seconds steam will start to come out of the

steam head.

Note: When rst lled or after running dry it can take up to 45

seconds for steam to be produced.

u It takes a few seconds for steam to enter the cleaning pad.

The steam mop will now glide easily over the surface to be

sanitised/cleaned.

u Push and pull the steam mop slowly across the oor to

thoroughly steam clean each section.

Note: During use you may turn off the steam pump by return-

ing the handle to the upright position, this convenient feature

will allow you to place the steam mop on the resting mat for

a short time so that you may move items of furniture, then

continue cleaning without the need to switch the appliance off.

u When you have nished using the steam mop, return the

handle (4) to the upright position and turn it ‘OFF’, place it

on the resting mat (7) and wait until the steam mop cools

down. (approximately ve minutes)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker FSM1610 T1 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Black Decker FSM1610 T1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info