586643
6
Zoom out
Zoom in
Vorherige Seite
1/76
Nächste Seite
6
ENGLISH
(Original instructions)
Note: Ensure the ller cap is rmly secured.
Note: Do not use chemical cleaners with your steam mop..
Attaching the carpet glider (Fig. G) (For use on
carpets only)
u Place carpet glider on the oor.
u Attach a cleaning pad to the unit.
u Lightly press the steam mop down onto the carpet glider
(14) until it clicks into place.
Caution! Always place your steam mop with the handle (10)
in the upright position when stationary and make sure the
steam mop is turned off when not in use.
Removing the carpet glider (Fig. G)
Caution! Always wear suitable shoes when changing the
carpet glider on your steam mop. Do not wear slippers or
open toed footwear.
u Return the handle (10) to the upright position and turn the
steam mop ‘OFF’.
u Wait until the steam mop cools down. (approximately ve
minutes)
u Place the front of your shoe onto the carpet glider removal
tab (22) and press down rmly.
u Lift the steam mop up off the carpet glider (14).
Caution! Always place your steam mop with the handle (10)
in the upright position when stationary and make sure the
steam mop is turned off when not in use.
Fitting a scent pack (Fig. I & J)
Warning! Return the handle (10) to the upright position and
turn the steam mop ‘OFF’. Wait until the steam mop cools
down. (approximately ve minutes).
u Slide the door release button (26), the door will open.
u Place the scent pack into the cavity (27).
u Close the door (28) py pushing it rmly down.
Attaching the hose and accessories to the Hand
held steam cleaner (Fig. K & L)
Warning! Inspect the seal (26) on the steam nozzle (4) and
hose (27) before each use. If the seal is missing or damaged
then please contact your nearest authorised repair agent. Do
not use the appliance.
Attaching the hose (Fig. K)
u Press in the clips (28) on either side of the hose (27).
u Press the hose (27) onto the steam nozzle (4) and release
the clips (28).
Important! Ensure that the hose (27) is securely fastened
before using the hand held steam cleaner. If steam escapes
from the joint then the hose is not correctly t, allow the unit to
cool then remove and re-t the hose.
Attaching the variable steam jet nozzle (Fig. L)
u Press in the clips (30) on either side of the variable steam
jet nozzle (31).
u Press the variable steam jet nozzle onto the steam nozzle
(4) or the hose (27) and release the clips (30).
Important! Ensure that the variable steam jet nozzle (31) is
securely fastened before using the hand held steam cleaner.
If steam escapes from the joint then the variable steam jet
nozzle is not correctly t, allow the unit to cool then remove
and re-t the variable steam jet nozzle.
Attaching other accessories (Fig. J)
u Align the lugs on the hose with the recesses on the acces-
sory.
u Press the accessory (29) onto the hose (27) and twist
anti-clockwise until the accessory clicks into place.
Note! The variable steam jet nozzle may be used without the
hose by tting them directly to steam nozzle. All other acces-
sories must be connected to the hose for use.
Removing the hose and accessories(Fig. K & L)
Warning! The Steam nozzle, variable steam jet nozzle, hose
and accessories become hot during use. Allow the unit and all
accessories to cool before removing any accessories.
Removing an accessory (Fig. K)
u Twist the accessory (29) clockwise then pull away from
the hose (27).
Removing the hose (Fig. K)
u Press in the clips (29) on either side of the hose (27) and
pull away from the steam nozzle (4).
Removing the variable steam jet nozzle (Fig. L)
u Press in the clips (30) on either side of the variable steam
jet nozzle (31) and pull away from the steam nozzle (4).
Use
Important! This unit will kill 99.9% of bacteria & germs when
used in accordance with this manual and with the micro bre
pad tted and a continuous run time of 90 seconds.
Switching on and off (Steam mop)
u To switch the appliance on, press the ON/OFF button (1).
It takes approximately 15 seconds for the steam mop to
heat up.
Note: When the steam mop is rst turned on the water res-
ervoir will glow red. Once the steam mop is ready to use the
water reservoir will glow blue.
u To switch the appliance off, press the ON/OFF button (1).
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

black-decker-fsmh1621s-t1

Suche zurücksetzen

  • wie kann ich den haltegriff vom Steammop entfernen Eingereicht am 29-3-2021 09:07

    Antworten Frage melden
  • wie kann ich den Griff des Dampfbesen entfernen um das Gerät zur Reparatur zu schicken?
    Eingereicht am 10-1-2017 12:42 Eingereicht am 5-4-2020 10:41

    Antworten Frage melden
  • wie kann ich den Griff des Dampfbesen entfernen um das Gerät zur Reparatur zu schicken? Eingereicht am 10-1-2017 12:42

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Black Decker FSMH1621S T1 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Black Decker FSMH1621S T1

Black Decker FSMH1621S T1 Zusatzinformation - Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch - 60 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info