Bedienungsanleitung Black Decker GL560PXC T5 (Seite 5 von 60) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

583265

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Edging

Best results are achieved on edges greater

than 50mm deep.

Note: Your trimmer is a maintenance tool for

trimming overhanging grass and should not

be used to create edges. Edges can be

created using an edging spade.

With the skid (25) on the grass edge and the

edge guide (9) hooked over the edge, pull

the unit along while keeping the edge guide

in contact with the lawn edge.

A closer cut can be achieved by angling

the trimmer.

If your trimmer is suitable for use with a

‘Detachable’ extension cord, loop a length of

cord through the cord restraint (3) to avoid

the plug and socket coming apart

accidentally if the cord is pulled.

How to convert between the trimming

and edging mode (Fig. 3)

In addition to conventional trimming (Fig. D),

your trimmer can be used to trim

overhanging grass along lawn edges and

flower beds (Fig. J).

To convert your trimmer between the

trimming and edging mode:

Unlock

• With the trimmer switched off and the

edge guide (9) resting on the ground,

place one hand on the switch handle

(20). Using your other hand, turn the

locking ring (4) anti-clockwise, as far as

it will go (approximately quarter of a

turn) (Fig. 3.1).

Convert

• While keeping hold of the switch handle,

grasp the trimmer body (1) and rotate

half a turn in the direction of the arrow

(24), until the body ‘clicks’ into position

(Fig. 3.2).

Lock

• While still holding the switch handle,

tighten the locking ring clockwise, using

the other hand. Only light finger pressure

is required to secure it (Fig. 3.3).

Replacement line

A new spool containing 10 metres of cutting line

(cat. no. A6481) may be purchased from your

Black & Decker dealer. Alternatively, replacement

line packs are available.

For maximum reliability, never put on a heavier or

lighter line (e.g. fishing line) which will prevent the

automatic feed from functioning, cause motor

failure or reduce cutting performance.

How to fit a new spool of cutting line

(Fig. 4 & 5)

• Disconnect your trimmer from the power

supply.

• Remove the spool cover by pushing the

spool cover tabs (13) inwards and

upwards (Fig. 4), then pull off (it is not

necessary to push both tabs in at the

same time). The empty spool can now

be withdrawn from the drive shaft.

• Remove any dirt or grass that may have

collected inside the spool housing (12)

and cover (8).

• Unwind approximately 9cm (3.5") of

cutting line (5) from the new spool (17).

Feed the cutting line through the eyelet

and then push the spool onto the centre

drive shaft (Fig. 5). Rotate as necessary

to fully seat the spool, taking care not to

trap the cutting line underneath the spool

and making sure that there is a

minimum of 9cm (3.5") protruding from

the spool housing.

• Replace the spool cover by aligning

both tabs on it (13) with the slots in the

spool housing and pushing them into

place. Make sure that both tabs are

securely located.

How to wind new line onto an empty

spool (Fig. 6 & 7)

• A maximum of 10 metres of new cutting

line can be wound onto the empty spool.

The spool has an ‘Indicator’ to help you

avoid winding an excessive quantity of

cutting line on the spool, as too much will

prevent the automatic feed system from

functioning (Fig. 6).

• Remove any remnant of old cutting line

from the spool (17).

• Push the end of the new cutting line into

one of the two holes provided in the

spool (17) and insert 20mm.

ENGLISH

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker GL560PXC T5 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Black Decker GL560PXC T5

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info