Bedienungsanleitung Black Decker GR345 T3 (Seite 5 von 64) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Spanisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

586079

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

Removing the grassbox from your mower:

Raise the grassflap. Lift the grassbox off

the mower and rest it on the lawn. Gently

lower the grassflap, then use both hands to

lift the full grassbox.

How to use your mower (Fig. E & F)

Observe all of the relevant warnings

when using your mower.

• Push the loop of cable through the slot

from the opposite side of the restraint

hook (Fig. E1), position the loop over the

hook and pull the cable back through the

slot. Your cable will now be restrained.

We recommend the directional method of

operation to obtain the maximum cutting

performance from your mower and to reduce

the risk of the trailing the extension lead from

entering the cutting path.

• Place the bulk of the supply cable on

the lawn close to the starting point

(see Fig. F2a, position 1).

• Hold the handle assembly with both

hands.

Warning! Do not attempt to operate your

mower with one hand - you must guide it

with both hands.

• Tilt the handle downwards to slightly raise

the front of your mower and to reduce

the risk of lawn damage whilst starting,

depress the safety lock-off button (12) on

the switchbox (10) and whilst still

depressed pull the switch lever (11)

towards you. Your mower will start and

you can now allow the lock-off button

to be released and lower your mower to

its proper cutting position, and commence

cutting.

• Proceed down the cutting area as shown

in Fig. F2a, working from position 1

towards position 2 and, on reaching

position 2, turn to the right and proceed

towards position 3. Continue to the end

of the cutting area, turn to the left and

proceed towards position 4. Continue

in the same manner as shown in Fig. F2a,

always working away from the cable.

Do not adopt the method as shown in

Fig. F2b, working towards the cable, as

this is dangerous practice.

Your mower will continue to operate whilst

you are pulling the switch lever. To stop

your mower release the switch lever.

When you have finished using your mower

we recommend that you clean all debris

from it before putting it away. Refer to the

‘Care and maintenance’ section.

Note: To obtain the best results cut your

lawn or grass area regularly and do not cut

when the grass is wet.

If, when grass cutting, loose grass is seen

to be scattering from beneath your mower,

the grassbox is probably full and should be

emptied.

Blade maintenance

The steel blade is designed to give a fine

finish in long or tough grass. The blade will

continue to cut even when it has become

blunt or burred. There is no need for it to

be razor sharp.

If, however, because of damage or wear

the cutting performance deteriorates, then

your mower may require a new blade, or at

least the existing blade to be sharpened.

We recommend that the steel blade is

sharpened or a new blade fitted at the

beginning of each season.

Replacement blades are available from

Black & Decker service agents.

Warning! When fitting a new blade use

only the Black & Decker replacement part

specified for your mower - do not attempt

to fit any other blade.

Fitting a new blade (Fig. G)

Observe all the relevant warnings before

changing the blade.

Warning! Disconnect your mower from the

electrical supply before changing the blade.

• Turn your mower over on its side so

that the underside of the mower body

(1) is exposed.

• Using a cloth placed over the blade or

heavy duty gloves to protect your hands,

grip the blade and, using the spanner

provided, loosen and remove the nut (16)

from the motor spindle. Turn the nut in an

anti-clockwise direction to loosen it.

• The blade can now be replaced and the

washer and nut reassembled.

Note: Do not remove the impeller (17) for

any reason.

Note: Some mowers are fitted with a clutch

washer, between the blade nut and the blade,

which must be reassembled at all times.

ENGLISH

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker GR345 T3 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Black Decker GR345 T3

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info