Bedienungsanleitung Black Decker GW200 T5 (Seite 8 von 14) (Englisch)

586345

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

• Replacement fans are available from a

Black & Decker service agent.

Warning! If the supply cord is damaged, it

must be replaced by a special cord or

assembly available from Black & Decker or a

recognised service agent (Black & Decker

part number: 372832-01 - UK only and part

number: 370017-04 - Australia and New

Zealand only).

The Black & Decker policy is one of continuous

improvement to their product and as such they

reserve the right to change product specification

without prior notice.

Double insulation

Your machine is double insulated. This

means that all external metal parts are

electrically isolated from the power supply.

This is achieved by placing an extra

insulation barrier between the electrical and

mechanical parts. Double insulation means

greater electrical safety and obviates the

necessity of having the machine earthed.

Electrical safety (UK only)

Your machine should always be switched off at the

mains before disconnecting any plug and socket

connector or extension cables.

Fuse replacement

If your machine is supplied with cable, fitted with a

non-re-wireable plug:

• The plug is fitted with a 13 amp fuse which is the

recommended fuse for your machine.

• Only use replacement fuses which are approved

to BS1362.

• When changing the fuse in your plug, always

ensure the fuse cover is refitted. If the fuse cover

is missing or damaged do not use the plug.

Note: Fuses do not give personal protection against

electric shock.

Plug replacement

• Disconnect the plug from the supply.

• Cut off the plug and dispose of immediately.

Insertion of a detached plug into a 13 amp

socket outlet may result in electric shock.

• Only fit BS1363A approved plugs fitted with the

correctly rated fuse.

• The cable wire colours, or a letter, will be marked

at the connection points of most good quality

plugs. Attach the wires to their respective points

in the plug (see above). Brown is for “Live” (L)

and blue is for “Neutral” (N).

• Before replacing the top cover of the mains plug

ensure that the cable restraint is holding the

outer sheath on the cable firmly and that the two

leads are correctly fixed at the terminal screws.

Fit a

BS1363A

approved

plug

Connect blue

to N (neutral)

Make sure that the

outer sheath of the

cable is held firmly

the clam

Fit the

recommended

fuse

Connect brown

to L (live)

240 volts AC only.

Never use a light

socket

Warning! Never connect live or neutral wires

to the earth pin marked “E” or .

Note: Do not wire an extension cable directly into

your machine yourself. Instead, take your machine to

your nearest Black & Decker service centre.

Increased safety can be obtained by having a

qualified electrician install a high sensitivity (30mA)

circuit breaker in the house wiring. If you do not have

such a circuit breaker installed, or you do not wish to

have one installed, then we strongly recommend that

the electrical power to the machine be supplied

through a high sensitivity residual current device

(RCD). The RCD is designed to provide a high degree

of personal protection against harmful electric current

should fault conditions occur.

Warning! The use of an RCD or other circuit

breaker unit does not release the operator of

the machine from the safety instructions and

safe working practices given in this manual.

Assembly prior to use (Fig. B & F)

Vacuum tube assembly (Fig. B1)

• Vacuum tubes must be assembled

together before use.

• To ease assembly apply soapy water

solution to joint area.

• Align location ribs on upper (4) and lower

(5) tubes.

• Push both parts firmly together until clip

is engaged, as per moulded detail.

(Never operate apart).

• In the interests of safety, it is not intended

for the tubes to be separated once

assembled.

Carrying strap assembly (GW200/GW250)

(Fig. B2)

• Fit carrying strap to powerhead if

required and adjust to suit user.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker GW200 T5 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Black Decker GW200 T5

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info