Bedienungsanleitung Black Decker GW254 T5 (Seite 11 von 60) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

586348

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

• Position C - Minimum blow speed.

• Once you have blown the debris/leaves

into a pile, you can convert to vacuum

mode to collect the debris.

Removing blow/vacuum tube (Fig. F)

• Switch off your product and disconnect

from the mains power supply. (If in vac

mode, remove the bag).

• To disconnect the tube from the

powerhead, depress the release button

as shown (Fig. F1), ensuring the tube

does not fall to the ground.

• The release button will not depress if

on/off switch is in the forward “on”

position.

Vacuum mode (Fig. E & F)

• Ensure your product is switched off and

disconnected from the mains power

supply.

• Attach the vacuum tube in the same

way as stated previously for the GW250

blow mode (Fig. E1 & Fig. E3).

To fit the bag assembly to your product:

• Align the notches on the bag fitting with

the recesses on the vacuum outlet

(fig. F2).

• Slide the bag fitting onto the vacuum

outlet and tighten the fitting (fig. F3).

• Locate the front of the collection bag

into the clip on the underside of the

vacuum tube (Fig. F4).

• Using the nylon band locate the rear

of the collection bag over the lip

positioned at the rear of the powerhead

(Fig. F5 & Fig. F6).

• Ensure the bag zip is closed before

operation (Fig. F5).

• Position the tube slightly above the

debris/leaves. Switch your product on,

then using a sweeping motion the

debris/leaves will be sucked up the

tube, shredded and thrown into the

collection bag (Fig. F7).

• As the bag fills the power of the suction

will decrease, switch off your product and

unplug from the mains power supply.

• To remove the bag, unclip it using the

nylon handle as shown (fig. F6) and

loosen the fitting. Unzip the bag and

empty it before continuing (fig. F9).

Fitting of the blower vac wheel

(Fig. G) (K models only)

• Disconnect your product from the

electricity supply before fitting the

wheel.

Note: To be used in the vac mode only.

• Locate the wheel onto the vac tube.

Fault finding

Disconnect from the mains power supply

before attempting any maintenance.

Failure to operate (1) Check the connection to the

power supply.

(2) Check the fuse in the plug, if

blown, replace (UK only).

(3) Check that the blow/vacuum

tube assembly is correctly fitted

to the powerhead.

(4) If the fuse continues to blow -

immediately disconnect from the

mains power supply and consult

your local Black & Decker

authorised repair agent.

Poor vacuum/ (1) Switch off - disconnect from

high pitched whinethe mains power supply, debris

should fall clear of the tube.

(2) Remove and empty the

collection bag.

(3) Check that both the inlet and

exit ports on the vacuum tube

are clear.

(4) Remove any debris from the

fan area.

(5) If poor vacuuming continues -

immediately disconnect from the

mains power supply and consult

your local Black & Decker

authorised repair agent.

Poor shredding (1) Switch off - disconnect from

the mains power supply and

remove the collection bag.

(2) Remove the vacuum tube

and inspect the fan.

(3) Clean any debris from the fan

blades.

(4) If the fan is cracked or

damaged, do not use - consult

your local Black & Decker

authorised repair agent.

ENGLISH

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker GW254 T5 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info