Bedienungsanleitung Black Decker GWC3600L (Seite 7 von 12) (Englisch)

527504

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

ENGLISH

(Original instructions)

u If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service

Centre in order to avoid a hazard.

Features

1. Blow tube

2. Vac tube

3. Collection bag

4. Blow/Vac

5. On/Off switch

6. Power select

7. Battery

8. Feet

Assembly

Warning! Before assembly, make sure that

the appliance is switched off and the battery is

removed.

Warning! Always wear protective gloves when

working with your cordless sweeper.

Blow tube assembly (g. A)

The blow tube (1) must be assembled before use.

u Align the latches (9) on the side of the blow tubes (1).

u Push the blow tube (1) rmly into each other until the

latches (9) click into place.

Note! The tubes should not be separated once assembled.

Note! The concentrator can be removed from the end of the

blow tube by rmly pressing the catch (22) and pulling.

Vac tube assembly (g. B)

The vac tube (2) must be assembled before use.

u Align the latches (10) on the side of the vac tube (2).

u Push the vac tube (2) rmly into each other until the

latches (10) click into place.

Note! The tubes should not be separated once assembled.

Fitting and removing the battery (g. C)

u To t the battery (7), line it up with the receptacle on the

tool. Slide the battery into the receptacle and push until

the battery snaps into place.

u To remove the battery, push the release button (11) while

at the same time pulling the battery out of the receptacle.

Attaching the second handle (g. E)

u Press in and hold both of the buttons (20) on the side of

the handle.

u Slide the second handle (21) in place over the buttons

(20).

Warning! Ensure that the teeth on the button are correctly

aligned in slots in the handle and that the handle is secure.

Adjusting the position of the second handle

The second handle (21) can be adjusted to provide optimum

balance and comfort.

u Press in the button (20) on the left side od the handle.

u Rotate the second handle (21) into the required position.

u Release the button (20).

Warning! Ensure that the teeth on the button are correctly

aligned in slots in the handle and that the handle is secure.

Use

Warning! Let the tool work at its own pace. Do not overload.

Charging the battery (g. D)

The battery needs to be charged before rst use and whenev-

er it fails to produce sufcient power on jobs that were easily

done before. The battery may become warm while charging;

this is normal and does not indicate a problem.

Warning! Do not charge the battery at ambient temperatures

below 10 °C or above 40 °C. Recommended charging tem-

perature: approx. 24 °C.

Note: The charger will not charge a battery if the cell

temperature is below approximately 0 °C or above 40 °C.

The battery should be left in the charger and the charger

will begin to charge automatically when the cell tempera-

ture warms up or cools down.

u To charge the battery (7), insert it into the charger (12).

The battery will only t into the charger in one way. Do

not force. Be sure that the battery is fully seated in the

charger.

u Plug in the charger and switch on at the mains.

The charging indicator (13) will ash green continuously

(slowly).

The charge is complete when the charging indicator (13)

lights green continuously. The charger and the battery can be

left connected indenitely with the LED illuminated. The LED

will change to ashing green (charging) state as the charger

occasionally tops off the battery charge. The charging indica-

tor (13) will be lit as long as the battery is connected to the

plugged-in charger.

u Charge discharged batteries within 1 week. Battery life will

be greatly diminished if stored in a discharged state.

Leaving the battery in the charger

The charger and battery pack can be left connected with the

LED glowing indenitely. The charger will keep the battery

pack fresh and fully charged.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker GWC3600L Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info