Bedienungsanleitung Black Decker KA170GT (Seite 4 von 8) (Englisch)

21829

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Electrical safety

This tool is double insulated; therefore no earth wire

is required. Always check that the power supply

corresponds to the voltage on the rating plate.

Additional safety instructions for Australia and

New Zealand

◆ This appliance is not intended for use by young or infirm

persons without supervision. Children must be supervised

to ensure they do not play with the appliance.

◆ If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service

Centre in order to avoid a hazard.

Additional safety instructions for sanders

◆ Always wear a dust mask whenever sanding.

◆ Thoroughly remove all dust after sanding.

◆ Take special care when sanding paint which is possibly

lead based or when sanding some woods and metal

which may produce toxic dust:

- Wear a dust mask specifically designed for protection

against lead paint dust and fumes and ensure that persons

within or entering the work area are also protected.

- Do not let children or pregnant women enter the work

area.

- Do not eat, drink or smoke in the work area.

- Dispose of dust particles and any other debris safely.

Features

1. On/off switch

2. Gel comfort grip

3. Dust extraction outlet

4. Dust bag

5. Sanding base

6. Paper clamp lever

7. Paper punch

Assembly

Warning! Make sure that the tool is switched off and

unplugged.

Fitting sanding sheets (fig. A - C)

Warning! Never use the tool without a sanding sheet or

accessory in place.

Fitting sanding sheets with nylon loops (fig. A)

◆ Make sure that the tool is switched off and unplugged.

◆ Press the sheet firmly and evenly onto the sanding base

(5), making sure that the holes in the sheet line up with

the holes in the base.

Fitting regular sanding sheets (fig. B)

◆ Make sure that the tool is switched off and unplugged.

◆ Soften the sanding sheet by rubbing its non-abrasive side

over the edge of a worktop.

◆ Press the paper clamp levers (6) upwards to release them

from the retaining grooves and open the paper clamps by

pressing them down.

◆ Place the sheet onto the sanding base.

◆ Insert the edge of the sanding sheet into the front paper

clamp as shown.

◆ Press the front paper clamp lever (6) downwards and

locate it in the retaining groove.

◆ While keeping a slight tension on the sheet, insert the

rear edge of the sheet into the rear paper clamp.

◆ Press the rear paper clamp lever (6) downwards and

locate it in the retaining groove.

Punching sanding sheets (fig. C)

The paper punch (7) is used for punching dust extraction holes

in sanding sheets without pre-punched holes. For optimum

convenience the paper punch can be fitted to a workbench

using the screw holes (8).

◆ Fit a sanding sheet.

◆ Hold the tool in position right above the paper punch (7).

◆ Press the tool with the sanding base (5) down into the

paper punch.

◆ Take the tool off the paper punch and check whether the

holes in the sanding sheet have been fully pierced.

Fitting and removing the dustbag (fig. D)

◆ Fit the dustbag (4) over the dust extraction outlet (3).

◆ To remove the dustbag, pull the dustbag to the rear and

off the outlet.

Use

Switching on and off

◆ To switch the tool on, press the I part of the on/off switch

(1).

◆ To switch the tool off, press the O part of the on/off switch.

Emptying the dustbag

The dustbag should be emptied every 10 minutes.

◆ Shake the dustbag to empty the contents.

Hints for optimum use

(fig. E)

◆ Hold the tool as shown.

◆ Do not exert too much pressure on the tool.

◆ Regularly check the condition of the sanding sheet.

Replace when necessary.

◆ Always sand with the grain of the wood.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker KA170GT Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Black Decker KA170GT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info