578194
7
Zoom out
Zoom in
Vorherige Seite
1/12
Nächste Seite
7
Labels on tool
The following pictograms are shown on the tool:
:
Warning! To reduce the risk of injury, the user must
read the instruction manual.
Electrical safety
#
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
u If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
1. On/off switch
2. Lock-on button
3. Adjustable handle
4. Tension lever
5. Retractable hood
6. Centring knob
7. Dust extraction outlet
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting a sanding belt (g. A)
Warning! Never use the tool without a sanding belt.
u Pull the tension lever (4) outward to release the tension on
the sanding belt (8).
u Remove the old sanding belt.
u Place a new sanding belt over the rollers. Ensure that the
arrow on the sanding belt points in the same direction as
the arrow on the tool.
u Push the tension lever (4) inward to tension the sanding belt.
Adjusting the sanding belt tracking (g. B)
To ensure a correct tracking, the sanding belt must be centred
over the rollers.
u Switch on the tool while holding it upside down.
u Turn the centring knob (6) as required until the tracking of
the belt is centred over the rollers.
Adjusting the handle (g. C)
The handle is adjustable to 3 positions.
u Unlock the handle (3) by pulling the locking handle (9)
outward.
u Adjust the handle in the desired position.
u Lock the handle by pushing the locking handle inward.
Retracting the hood (g. D)
The hood can be retracted for sanding in conned spaces.
Warning! The hood can only be retracted when the adjustable
handle is in the up position.
u Adjust the handle (3) in the straight-up position.
u Lift the hood (5) up.
u To close the hood, pull the tab (10) sideways rst.
Fitting and removing the dust cassette (g. E)
u Slide the dust cassette (11) over the dust extraction outlet (7).
u To remove the dust cassette, slide it off the outlet.
Connecting a vacuum cleaner (g. F)
u Slide the adaptor (12) over the dust extraction outlet (7).
u Connect the hose of the vacuum cleaner to the adaptor.
Use
Warning! Let the tool work at its own pace. Do not overload.
Switching on and off
u To switch the tool on, press the on/off switch (1).
u For continuous operation, press the lock-on button (2) and
release the on/off switch.
u To switch the tool off, release the on/off switch. To switch
the tool off when in continuous operation, press the on/off
switch once more and release it.
Emptying the dust cassette (g. E & G)
The dust cassette should be emptied every 10 minutes of use.
u Remove the dust cassette (11) to the rear and off the tool.
u Remove the cover (13) by twisting it clockwise.
u Hold dust cassette with the lter (14) facing down and
shake the cassette to empty the contents. Shake the
cover to empty the contents.
u Ret the cover (13) onto the dust cassette, twisting it
counterclockwise until it locks into place.
u Ret the dust cassette onto the tool.
Cleaning the dust cassette lter
The dust cassette lter is re-usable and should be cleaned
regularly.
u Empty the dust cassette (11) as described above.
u Pull the lter (14) off the dust cassette.
Warning! Do not twist the lter.
u Shake off excess dust by tapping the lter into a dustbin.
Warning! Do not brush or use compressed air or sharp
objects to clean the lter. Do not wash the lter.
u Replace the lter.
u Ret the cover.
u Ret the dust cassette onto the tool.
7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Black Decker KA88 T2 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Black Decker KA88 T2

Black Decker KA88 T2 Bedienungsanleitung - Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Spanisch - 76 seiten

Black Decker KA88 T2 Bedienungsanleitung - Polnisch - 16 seiten

Black Decker KA88 T2 Bedienungsanleitung - Polnisch - 76 seiten

Black Decker KA88 T2 Bedienungsanleitung - Türkisch - 12 seiten

Black Decker KA88 T2 Bedienungsanleitung - Türkisch, Schwedisch, Norwegisch, Finnisch - 76 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info