Bedienungsanleitung Black Decker KC7251 (Seite 26 von 72) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

472996

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

ENGLISH

• Never attempt to connect two chargers together.

• Always disconnect the supply before making or

breaking connections to the battery.

• Be aware that this tool is always in an operating

condition, because it does not have to be plugged

into an electrical outlet. Keep the switch control

lever in the “Off” position when the tool is not in use

or when changing accessories.

• When drilling or driving screws into walls, floors

etc., check wherever “live” electrical wires may be

encountered. Do not touch any front metal parts of

the tool! Hold the tool only by the plastic housing.

• Do not store the tool in locations where the

temperature may reach or exceed 50˚C (120˚F) (such

as outside sheds or metal buildings in summer).

• Do not incinerate the drill/driver even if it is severely

damaged or completely worn out. The battery pack

can explode in a fire.

• A small leakage of liquid from the battery cells may

occur under extreme usage, charging or

temperature conditions. This does not indicate a

failure. However, if the outer seal is broken and this

leakage gets on your skin:

• Wash quickly with soap and water.

• Neutralise with a mild acid such as lemon juice

or vinegar.

• If battery liquid gets into your eyes, flush them

with clean water for a minimum of 10 minutes and

seek immediate medical attention.

(Medical note: The liquid is a 25-35% solution of

potassium hydroxide.)

• Do not attempt to open the housing of your drill or

charger.

• The supply cord of the charger should not be

replaced by the customer; if the cord is damaged it

should be replaced at an authorised Black & Decker

service repair agent.

• Ensure that the battery pack is correct for the tool.

• Ensure that the outside surface of the battery pack

or tool is clean and dry before plugging into the

charger.

• Ensure that the battery is charged using the correct

charger provided with the tool or recommended by

the manufacturer. Incorrect use may result in a risk

of electric shock, overheating or leakage of

corrosive liquid from the battery.

• Do not attempt to recharge non-rechargeable

batteries.

Save these instructions!

ELECTRICAL SAFETY

Be sure the supply is the same as the voltage given on the

rating plate. Your charger is fitted with a two-core cable

and plug.

MAINS PLUG REPLACEMENT

Should the mains plug or cordset of the product be

damaged, it must only be replaced by an authorised

Black & Decker service agent because special

purpose tools are required.

MAINS PLUG REPLACEMENT ON 1 HOUR CHARGER

(UK ONLY)

If you are using a 1 hour charger and the mains plug

needs replacing, and you are competent to do this,

proceed as instructed below.

If you are in doubt, contact a Black & Decker service

agent or a qualified electrician.

• Disconnect the plug from the power supply.

• Cut off the plug and dispose of safely. A plug with

bared copper conductors is very dangerous if

engaged in a live socket outlet.

• Only fit BS1363A approved plugs fitted with the

correctly rated fuse.

Note: Fuses do not give personal protection against

electric shock.

• The cable wire colours, or a letter, will be marked at

the connection point of most good quality plugs.

Attach the wires to their respective points in the

plug (see diagram). Brown is L (live) and blue is N

(neutral).

Fit a plug

approved

to BS1363A

Connect

blue to

N (neutral)

Make sure that

the outer sheath

of the cable is held

firmly by the clamp

Fit a 5 amp fuse

Connect

brown to

L (live)

240 volts AC

only. Never use

a light socket

• Before replacing the top cover of the plug ensure

that the cable restraint is holding the outer sheath of

the cable firmly and that the two leads are correctly

fixed at the terminal screws. If the fuse cover is

missing or damaged do not use the plug.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker KC7251 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info