Bedienungsanleitung Black Decker KW850 T1 (Seite 10 von 100) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

577912

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

ENGLISH

Keep handles and switches dry, clean and free

from oil and grease.

20.Repairs

This tool complies with relevant safety

requirements. Repairs should only be carried

out by qualified persons using original spare

parts; otherwise this may result in considerable

danger to the user.

Additional safety instructions for routers

Wear safety glasses or goggles when

operating this tool.

◆ Only use router bits with a shank diameter

equal to the size of the collet installed in the

tool.

◆ Only use router bits suitable for the no-load

speed of the tool.

◆ Never use router bits with a diameter

exceeding the maximum diameter specified in

the technical data section.

◆ Do not use the tool in an inverted position.

◆ Do not attempt to use the tool in a stationary

mode.

◆ Take special care when routing MDF or

surfaces coated with lead-based paint:

- Wear a dust mask specifically designed for

protection against lead paint dust and fumes

and ensure that persons within or entering

the work area are also protected.

- Do not let children or pregnant women enter

the work area.

- Do not eat, drink or smoke in the work area.

- Dispose of dust particles and any other

debris safely.

Additional safety instructions for Australia and

New Zealand

◆ This appliance is not intended for use by

young or infirm persons without supervision.

Children must be supervised to ensure they do

not play with the appliance.

◆ If the supply cord is damaged, it must be

replaced by the manufacturer or an authorised

Black & Decker Service Centre in order to

avoid a hazard.

ELECTRICAL SAFETY

The electric motor has been designed for one

voltage only. Always check that the power supply

corresponds to the voltage on the rating plate.

This tool is double insulated in accordance

with EN 50144; therefore no earth wire is

required.

Mains plug replacement (U.K. & Ireland only)

◆ Should your mains plug need replacing and

you are competent to do this, proceed as

instructed below. If you are in doubt, contact

an authorised repair agent or a qualified

electrician.

◆ Disconnect the plug from the supply and

remove the fuse from the plug.

◆ Cut off the plug and dispose of it safely; a plug

with bared copper conductors is dangerous if

engaged in a live socket outlet.

◆ Only fit 13 Amperes BS1363A approved plugs

fitted with the correctly rated fuse (1).

◆ The cable wire colours, or a letter, will be marked

at the connection points of most good quality

plugs. Attach the wires to their respective

points in the plug (see above). Brown is for

Live (L) (2), blue is for Neutral (N) (4).

◆ Before replacing the top cover of the mains

plug ensure that the cable restraint (3) is

holding the outer sheath of the cable firmly

and that the leads are correctly fixed at the

terminal screws.

◆ If the plug has a fuse cover, make sure that the

fuse cover is fitted. Do not use the plug if the

fuse cover is missing or damaged.

Never use a light socket.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker KW850 T1 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info