Bedienungsanleitung Black Decker KX3300 T2 (Seite 6 von 12) (Englisch)

578614

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

ENGLISH

(Original instructions)

Electrical safety

This product must be earthed. Always check that

the power supply corresponds to the voltage on

the rating plate.

Power plugs must match the outlet. Never modify the plug in

any way. Unmodied plugs and matching outlets will reduce

the risk of electric shock.

Extension cables & class 1 product

u A 3 core cable must be used as your appliance is earthed

and of class 1 construction.

Features

1. Boiler carrying handle

2. Pressure relief valve

3. Boiler reservoir

4. Water level indication

5. Hose

6. Steam plate

7. Filler cap

Assembly

Fitting the hose (g. A and B)

u Screw one end of the hose (5) to the hose connector on

the boiler tank. Check that the hose has been connected

properly.

u Connect the other end of the hose (5) to the steam plate.

Check that the hose has been connected properly.

Use

Surfaces may become hot in use. The ller cap

may be hot during use and during the cool down

period.

Initial lling of the boiler reservoir (g. C)

Warning! Make sure that the appliance is unplugged.

u Unscrew and remove the ller cap (7).

Note: When lling the boiler, use clean tap water only.

u Fill the boiler reservoir (3) with water. Do not overll the

reservoir past the MAX indicator (maximum 4 litres).

u Replace the boiler ller cap (7), do not overtighten.

u Plug the mains plug into the power supply.

Reaching temperature (g. D)

u Depending upon the temperature of the water used to ll

the reservoir (3), the appliance will take between 6 and 11

minutes to start producing steam.

Relling the boiler reservoir

u Disconnect the appliance from the mains supply.

u Wait at least 2 minutes for the water to cool and the pres-

sure to decrease before removing the boiler ller cap (7).

Warning! The ller cap may be hot during use and during the

cool down period.

u Unscrew and remove the ller cap (7).

u Fill the boiler reservoir (3) with clean tap water. Do not

overll the reservoir past the MAX indicator (maximum 4

litres).

u Replace the boiler ller cap (7), do not overtighten.

u Plug the mains plug into the power supply.

Using the wallpaper stripper (g. E)

u Check the state of your plaster before you start work

as high temperature steam can loosen weak, porous or

poorly bonded plaster. Plaster is also loosened more read-

ily in areas of cracks, holes or if the steam plate is held in

one position for too long.

u You may be able to detect if you have weak plaster by

tapping a few areas of the walls with your knuckles. If this

produces a hollow sound, we recommend proceeding only

with extreme care.

u In all cases test out the wallpaper stripper on a small area,

about 100 cm2 , before starting work properly.

u If at any stage nishing plaster is loosened or you hear a

crack, do not continue. The wallpaper stripper is safe for

drywall/plaster board surfaces.

u Due to the heat generated by this product, it is possible

that certain surfaces, ie. carpets, soft furniture, table tops,

cabinets etc., could be marked or damaged. To prevent

this, ensure a wooden board or other barrier is placed

under the boiler to prevent the heat damaging the surface.

Dust sheets or newspapers are not adequate for this

purpose.

u For best results, remove wallpaper with a scraper. Scrape

off wallpaper in a downward direction (g. F).

u Always wear protection when removing wallpaper from the

ceiling. Be careful of condensation collecting in the steam

plate as hot water may drip (g. G and H). Empty the

steam plate regularly and never use directly above your

head.

u Always place the steam plate in a suitable container when

left unattended, even for a few seconds, and keep the

steam plate facing away from you when in use (g. I and

J).

Storage

u Allow the appliance to cool for at least 10 minutes.

u Empty the appliance.

u Store the appliance upright in a dry place.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Black Decker KX3300 T2 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Black Decker KX3300 T2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info