Unit not plugged in.
On/Off switch is in the Off
position.
Wand trigger not being
squeezed.
GFCI tripped.
Water faucet not fully
turned on.
Water inlet filter clogged.
Nozzle worn.
Pump is sucking air.
Water supply restricted.
Not enough inlet water
supply.
Pump is sucking air.
Water inlet filter clogged.
Discharge nozzle is
obstructed.
Detergent container is
empty.
Detergent bottle or suction
tube not properly
connected.
Detergent is too thick.
Filter on detergent suction
tube is clogged.
Damaged or clogged
detergent suction tube.
Discharge nozzle is
obstructed.
Loose fittings.
Missing/worn rubber
washer.
Spray wand not properly
attached.
Plug in power cord.
Turn switch to the “On” position.
Squeeze trigger with switch in
“ON” position.
Press reset button at GFCI on plug
end of cord.
Open water valve fully.
Remove filter and rinse to clean.
Contact B&D Customer Service
Representative at 1-800-544-6986.
Check that hoses and fittings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until a
steady flow of water emerges from the
nozzle.
Check water hose for kinks, leaks and
blockage.
Turn water on full force - check hose
for leaks and kinks.
Check that hoses and fittings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until a
steady flow of water emerges from the
nozzle.
Remove filter (B1) and rinse to clean. Fig. L
Blow out or remove debris with tool
provided.
Add more detergent.
Check connections.
Use detergent recommended for use
in pressure washers only.
Run warm water through filter to
remove debris.
Remove obstruction or replace
detergent suction tube.
Blow out or remove debris with tool
provided.
Tighten fittings.
Replace washer in hose adapter.
Insert the spray wand into the wand
extension. Push in and turn to lock
spray wand into place.
Motor does not start.
Unit does not reach
high pressure.
Output pressure
varies high/low.
No detergent.
Garden hose
connection leaks.
Spray wand or
extension leaks.
10
TROUBLESHOOTING GUIDE
Symptom Cause Solution
L
