585428

Black Decker STC1840 Seite 9

9
Zoom out
Zoom in
Vorherige Seite
1/120
Nächste Seite
8
ENGLISH
(Original instructions)
9
ENGLISH
(Original instructions)
Warning! Ensure that the teeth on the button are correctly
aligned in slots in the handle and that the handle is secure.
Adjusting the position of the auxiliary handle (g.
G)
The auxiliary handle (3) can be adjusted to provide optimum
balance and comfort.
u Loosen the knob (12) on the bolt (11) by truning it counter-
clockwise.
u Gently slide the second handle up and down the tube (10)
to the desired hight for comfort.
u Tighten the knob (12) onto the bolt by turning it clockwise.
Adjusting the height of the tool (g. H)
This tool has a telescopic mechanism, allowing you to set it to
a comfortable height.
To adjust the height setting, proceed as follows:
u Release the hight adjust locking clamp (5).
u Gently pull the tube (10) up or down to the desired height.
u Close the hight adjust locking clamp (5).
Releasing the cutting line
In transit, the cutting line is taped to the spool housing.
Warning! Before assembly, remove the battery from the tool.
u Remove the tape holding the cutting line to the spool
housing (9).
Fitting and removing the battery (g. $)
u To t the battery (2), line it up with the receptacle on the
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
u To remove the battery, push the release button ($) while at
the same time pulling the battery out of the receptacle.
Use
Warning! Let the tool work at its own pace. Do not overload.
Charging the battery (g. C)
The battery needs to be charged before rst use and whenev-
er it fails to produce sufcient power on jobs that were easily
done before. The battery may become warm while charging;
this is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging tem-
perature: approx. 24 °C.
Note: The charger will not charge a battery if the cell
temperature is below approximately 10 °C or above 40 °C.
The battery should be left in the charger and the charger
will begin to charge automatically when the cell tempera-
ture warms up or cools down.
u To charge the battery (2), insert it into the charger. The
battery will only t into the charger in one way. Do not
force. Be sure that the battery is fully seated in the
charger.
u Plug in the charger and switch on at the mains.
The charging indicator will ash green continuously (slowly).
The charge is complete when the charging indicator lights
green continuously. The charger and the battery can be left
connected indenitely with the LED illuminated. The LED will
change to ashing green (charging) state as the charger oc-
casionally tops up the battery charge. The charging indicator
will be lit as long as the battery is connected to the plugged-in
charger.
u Charge discharged batteries within 1 week. Battery life will
be greatly diminished if stored in a discharged state.
Leaving the battery in the charger
The charger and battery pack can be left connected with the
LED glowing indenitely. The charger will keep the battery
pack fresh and fully charged.
Charger diagnostics
If the charger detects a weak or damaged battery, the charg-
ing indicator will ash red at a fast rate. Proceed as follows:
u Re-insert the battery (2).
u If the charging indicators continues ashing red at a fast
rate, use a different battery to determine if the charging
process works properly.
u If the replaced battery charges correctly, the original
battery is defective and should be returned to a service
centre for recycling.
u If the new battery gives the same indication as the original
battery, take the charger to be tested at an authorised
services centre.
Note: It may take as long as 30 minutes to determine that
the battery is defective. If the battery is too hot or too
cold, the LED will alternately blink red, fast and slow, one
ash at each speed and repeat.
Switching on and off
u To switch the trimmer on, pull the lock off button (13)
(shown in inset, gure I) back toward the battery (2) and
then squeeze the trigger switch (1).
u To switch the trimmer off, release the trigger switch.
Operating the trimmer
u With the unit on, angle unit and slowly swing the trimmer
side to side as shown in gure I.
u Maintain a cutting angle of 5° to 10° as shown in gure I1.
Do not exceed 10° (g I2). Cut with the tip of the line. To
keep distance from hard surfaces use edge guide (7).
u Maintain a minimum distance of 24 inches (609.6 mm)
between the guard and your feet as shown in (g. I1). To
acheive this distance adjust the overall height of the trim-
mer as shown in (g. H).
Converting to edging mode (g. J & K)
The wheeled edge guide should only be used when in the
edging mode. The trimmer can be used in trimming mode or
edging mode to trim overhanging grass along lawn edges and
ower beds. For edging, the trimmer head should be in the
position shown in (g. K). If it is not:
u Remove the battery from the trimmer.
u Press and hold the head-release button (14) as shown in
(g. J).
u While holding the auxillary handle (3), rotate the head (6)
counterclockwise.
… 9 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

black-decker-stc1840

Suche zurücksetzen

  • Betr. Handsauger NVB220WC
    Frage:Ist der zugehörige Staubfilter nachbestellbar? Eingereicht am 10-9-2018 17:10

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Black Decker STC1840 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info